Current Path : /compat/linux/proc/68247/root/compat/linux/proc/68247/root/compat/linux/proc/3760/root/sys/dev/si/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
Current File : //compat/linux/proc/68247/root/compat/linux/proc/68247/root/compat/linux/proc/3760/root/sys/dev/si/si_isa.c |
/*- * Device driver for Specialix range (SI/XIO) of serial line multiplexors. * * Copyright (C) 2000, Peter Wemm <peter@netplex.com.au> * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notices, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notices, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * THIS SOFTWARE IS PROVIDED BY ``AS IS'' AND ANY EXPRESS OR IMPLIED * WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF * MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN * NO EVENT SHALL THE AUTHORS BE LIABLE. * */ #include <sys/cdefs.h> __FBSDID("$FreeBSD: release/9.1.0/sys/dev/si/si_isa.c 166914 2007-02-23 19:34:52Z imp $"); #include "opt_debug_si.h" #include <sys/param.h> #include <sys/systm.h> #include <sys/kernel.h> #include <sys/module.h> #include <sys/bus.h> #include <machine/bus.h> #include <sys/rman.h> #include <machine/resource.h> #include <dev/si/sireg.h> #include <dev/si/sivar.h> #include <isa/isavar.h> /* Look for a valid board at the given mem addr */ static int si_isa_probe(device_t dev) { struct si_softc *sc; int type; u_int i, ramsize; volatile unsigned char was, *ux; volatile unsigned char *maddr; unsigned char *paddr; int unit; /* No pnp support */ if (isa_get_vendorid(dev)) return (ENXIO); sc = device_get_softc(dev); unit = device_get_unit(dev); sc->sc_mem_rid = 0; sc->sc_mem_res = bus_alloc_resource(dev, SYS_RES_MEMORY, &sc->sc_mem_rid, 0, ~0, SIPROBEALLOC, RF_ACTIVE); if (!sc->sc_mem_res) { device_printf(dev, "cannot allocate memory resource\n"); return ENXIO; } paddr = (caddr_t)rman_get_start(sc->sc_mem_res);/* physical */ maddr = rman_get_virtual(sc->sc_mem_res); /* in kvm */ DPRINT((0, DBG_AUTOBOOT, "si%d: probe at virtual=0x%x physical=0x%x\n", unit, maddr, paddr)); /* * this is a lie, but it's easier than trying to handle caching * and ram conflicts in the >1M and <16M region. */ if ((caddr_t)paddr < (caddr_t)0xA0000 || (caddr_t)paddr >= (caddr_t)0x100000) { device_printf(dev, "maddr (%p) out of range\n", paddr); goto fail; } if (((uintptr_t)paddr & 0x7fff) != 0) { device_printf(dev, "maddr (%p) not on 32k boundary\n", paddr); goto fail; } /* Is there anything out there? (0x17 is just an arbitrary number) */ *maddr = 0x17; if (*maddr != 0x17) { device_printf(dev, "0x17 check fail at phys %p\n", paddr); goto fail; } /* * Let's look first for a JET ISA card, since that's pretty easy * * All jet hosts are supposed to have this string in the IDROM, * but it's not worth checking on self-IDing busses like PCI. */ { unsigned char *jet_chk_str = "JET HOST BY KEV#"; for (i = 0; i < strlen(jet_chk_str); i++) if (jet_chk_str[i] != *(maddr + SIJETIDSTR + 2 * i)) goto try_mk2; } DPRINT((0, DBG_AUTOBOOT|DBG_FAIL, "si%d: JET first check - 0x%x\n", unit, (*(maddr+SIJETIDBASE)))); if (*(maddr+SIJETIDBASE) != (SISPLXID&0xff)) goto try_mk2; DPRINT((0, DBG_AUTOBOOT|DBG_FAIL, "si%d: JET second check - 0x%x\n", unit, (*(maddr+SIJETIDBASE+2)))); if (*(maddr+SIJETIDBASE+2) != ((SISPLXID&0xff00)>>8)) goto try_mk2; /* It must be a Jet ISA or RIO card */ DPRINT((0, DBG_AUTOBOOT|DBG_FAIL, "si%d: JET id check - 0x%x\n", unit, (*(maddr+SIUNIQID)))); if ((*(maddr+SIUNIQID) & 0xf0) != 0x20) goto try_mk2; /* It must be a Jet ISA SI/XIO card */ *(maddr + SIJETCONFIG) = 0; type = SIJETISA; ramsize = SIJET_RAMSIZE; goto got_card; try_mk2: /* * OK, now to see if whatever responded is really an SI card. * Try for a MK II next (SIHOST2) */ for (i = SIPLSIG; i < SIPLSIG + 8; i++) if ((*(maddr+i) & 7) != (~(unsigned char)i & 7)) goto try_mk1; /* It must be an SIHOST2 */ *(maddr + SIPLRESET) = 0; *(maddr + SIPLIRQCLR) = 0; *(maddr + SIPLIRQSET) = 0x10; type = SIHOST2; ramsize = SIHOST2_RAMSIZE; goto got_card; try_mk1: /* * Its not a MK II, so try for a MK I (SIHOST) */ *(maddr+SIRESET) = 0x0; /* reset the card */ *(maddr+SIINTCL) = 0x0; /* clear int */ *(maddr+SIRAM) = 0x17; if (*(maddr+SIRAM) != (unsigned char)0x17) goto fail; *(maddr+0x7ff8) = 0x17; if (*(maddr+0x7ff8) != (unsigned char)0x17) { device_printf(dev, "0x17 check fail at phys %p = 0x%x\n", paddr+0x77f8, *(maddr+0x77f8)); goto fail; } /* It must be an SIHOST (maybe?) - there must be a better way XXX */ type = SIHOST; ramsize = SIHOST_RAMSIZE; got_card: DPRINT((0, DBG_AUTOBOOT, "si%d: found type %d card, try memory test\n", unit, type)); /* Try the acid test */ ux = maddr + SIRAM; for (i = 0; i < ramsize; i++, ux++) *ux = (unsigned char)(i&0xff); ux = maddr + SIRAM; for (i = 0; i < ramsize; i++, ux++) { if ((was = *ux) != (unsigned char)(i&0xff)) { device_printf(dev, "memtest fail at phys %p, was %x should be %x\n", paddr + i, was, i & 0xff); goto fail; } } /* clear out the RAM */ ux = maddr + SIRAM; for (i = 0; i < ramsize; i++) *ux++ = 0; ux = maddr + SIRAM; for (i = 0; i < ramsize; i++) { if ((was = *ux++) != 0) { device_printf(dev, "clear fail at phys %p, was %x\n", paddr + i, was); goto fail; } } /* * Success, we've found a valid board, now fill in * the adapter structure. */ switch (type) { case SIHOST2: switch (isa_get_irq(dev)) { case 11: case 12: case 15: break; default: device_printf(dev, "bad IRQ value - %d (11, 12, 15 allowed)\n", isa_get_irq(dev)); goto fail; } sc->sc_memsize = SIHOST2_MEMSIZE; break; case SIHOST: switch (isa_get_irq(dev)) { case 11: case 12: case 15: break; default: device_printf(dev, "bad IRQ value - %d (11, 12, 15 allowed)\n", isa_get_irq(dev)); goto fail; } sc->sc_memsize = SIHOST_MEMSIZE; break; case SIJETISA: switch (isa_get_irq(dev)) { case 9: case 10: case 11: case 12: case 15: break; default: device_printf(dev, "bad IRQ value - %d (9, 10, 11, 12, 15 allowed)\n", isa_get_irq(dev)); goto fail; } sc->sc_memsize = SIJETISA_MEMSIZE; break; case SIMCA: /* MCA */ default: device_printf(dev, "card type %d not supported\n", type); goto fail; } sc->sc_type = type; bus_release_resource(dev, SYS_RES_MEMORY, sc->sc_mem_rid, sc->sc_mem_res); sc->sc_mem_res = 0; return (0); /* success! */ fail: if (sc->sc_mem_res) { bus_release_resource(dev, SYS_RES_MEMORY, sc->sc_mem_rid, sc->sc_mem_res); sc->sc_mem_res = 0; } return(EINVAL); } static int si_isa_attach(device_t dev) { int error; void *ih; struct si_softc *sc; error = 0; ih = NULL; sc = device_get_softc(dev); sc->sc_mem_rid = 0; sc->sc_mem_res = bus_alloc_resource_any(dev, SYS_RES_MEMORY, &sc->sc_mem_rid, RF_ACTIVE); if (!sc->sc_mem_res) { device_printf(dev, "couldn't map memory\n"); goto fail; } sc->sc_paddr = (caddr_t)rman_get_start(sc->sc_mem_res); sc->sc_maddr = rman_get_virtual(sc->sc_mem_res); sc->sc_irq_rid = 0; sc->sc_irq_res = bus_alloc_resource_any(dev, SYS_RES_IRQ, &sc->sc_irq_rid, RF_ACTIVE | RF_SHAREABLE); if (!sc->sc_irq_res) { device_printf(dev, "couldn't allocate interrupt\n"); goto fail; } sc->sc_irq = rman_get_start(sc->sc_irq_res); error = bus_setup_intr(dev, sc->sc_irq_res, INTR_TYPE_TTY, NULL, si_intr, sc, &ih); if (error) { device_printf(dev, "couldn't activate interrupt\n"); goto fail; } error = siattach(dev); if (error) goto fail; return (0); /* success */ fail: if (error == 0) error = ENXIO; if (sc->sc_irq_res) { if (ih) bus_teardown_intr(dev, sc->sc_irq_res, ih); bus_release_resource(dev, SYS_RES_IRQ, sc->sc_irq_rid, sc->sc_irq_res); sc->sc_irq_res = 0; } if (sc->sc_mem_res) { bus_release_resource(dev, SYS_RES_MEMORY, sc->sc_mem_rid, sc->sc_mem_res); sc->sc_mem_res = 0; } return (error); } static device_method_t si_isa_methods[] = { /* Device interface */ DEVMETHOD(device_probe, si_isa_probe), DEVMETHOD(device_attach, si_isa_attach), { 0, 0 } }; static driver_t si_isa_driver = { "si", si_isa_methods, sizeof(struct si_softc), }; DRIVER_MODULE(si, isa, si_isa_driver, si_devclass, 0, 0);