| Current Path : /compat/linux/proc/68247/root/compat/linux/proc/68247/root/compat/linux/proc/68247/root/usr/src/share/man/man4/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //compat/linux/proc/68247/root/compat/linux/proc/68247/root/compat/linux/proc/68247/root/usr/src/share/man/man4/amr.4 |
.\" .\" Copyright (c) 2000 Jeroen Ruigrok van der Werven .\" All rights reserved. .\" .\" Redistribution and use in source and binary forms, with or without .\" modification, are permitted provided that the following conditions .\" are met: .\" 1. Redistributions of source code must retain the above copyright .\" notice, this list of conditions and the following disclaimer. .\" 2. The name of the author may not be used to endorse or promote products .\" derived from this software without specific prior written permission .\" .\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR .\" IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES .\" OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. .\" IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT, .\" INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT .\" NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, .\" DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY .\" THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT .\" (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF .\" THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. .\" .\" $FreeBSD: release/9.1.0/share/man/man4/amr.4 159735 2006-06-18 14:45:28Z brueffer $ .\" .Dd March 29, 2006 .Dt AMR 4 .Os .Sh NAME .Nm amr .Nd MegaRAID SCSI/ATA/SATA RAID driver .Sh SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: .Bd -ragged -offset indent .Cd "device pci" .Cd "device scbus" .Cd "device amr" .Ed .Pp Alternatively, to load the driver as a module at boot time, place the following line in .Xr loader.conf 5 : .Bd -literal -offset indent amr_load="YES" .Ed .Sh DESCRIPTION The .Nm driver provides support for LSI Logic MegaRAID SCSI, ATA and SATA RAID controllers and legacy American Megatrends MegaRAID SCSI RAID controllers, including models relabeled and sold by Dell and Hewlett-Packard. .Pp LSI MegaRAID SAS controllers are supported by .Xr mfi 4 and will not work with this driver. .Sh HARDWARE Controllers supported by the .Nm driver include: .Pp .Bl -bullet -compact .It MegaRAID SATA 150-4 .It MegaRAID SATA 150-6 .It MegaRAID SATA 300-4X .It MegaRAID SATA 300-8X .It MegaRAID SCSI 320-1E .It MegaRAID SCSI 320-2E .It MegaRAID SCSI 320-4E .It MegaRAID SCSI 320-0X .It MegaRAID SCSI 320-2X .It MegaRAID SCSI 320-4X .It MegaRAID SCSI 320-0 .It MegaRAID SCSI 320-1 .It MegaRAID SCSI 320-2 .It MegaRAID SCSI 320-4 .It MegaRAID Series 418 .It MegaRAID i4 133 RAID .It MegaRAID Elite 1500 (Series 467) .It MegaRAID Elite 1600 (Series 493) .It MegaRAID Elite 1650 (Series 4xx) .It MegaRAID Enterprise 1200 (Series 428) .It MegaRAID Enterprise 1300 (Series 434) .It MegaRAID Enterprise 1400 (Series 438) .It MegaRAID Enterprise 1500 (Series 467) .It MegaRAID Enterprise 1600 (Series 471) .It MegaRAID Express 100 (Series 466WS) .It MegaRAID Express 200 (Series 466) .It MegaRAID Express 300 (Series 490) .It MegaRAID Express 500 (Series 475) .It Dell PERC .It Dell PERC 2/SC .It Dell PERC 2/DC .It Dell PERC 3/DCL .It Dell PERC 3/QC .It Dell PERC 4/DC .It Dell PERC 4/IM .It Dell PERC 4/SC .It Dell PERC 4/Di .It Dell PERC 4e/DC .It Dell PERC 4e/Di .It Dell PERC 4e/Si .It Dell PERC 4ei .It HP NetRAID-1/Si .It HP NetRAID-3/Si (D4943A) .It HP Embedded NetRAID .It Intel RAID Controller SRCS16 .It Intel RAID Controller SRCU42X .El .Sh DIAGNOSTICS .Ss Driver initialisation/shutdown phase .Bl -diag .It amr%d: memory window not available .It amr%d: I/O window not available .Pp The PCI BIOS did not allocate resources necessary for the correct operation of the controller. The driver cannot attach to this controller. .It amr%d: busmaster bit not set, enabling .Pp The PCI BIOS did not enable busmaster DMA, which is required for the correct operation of the controller. The driver has enabled this bit and initialisation will proceed. .It amr%d: can't allocate register window .It amr%d: can't allocate interrupt .It amr%d: can't set up interrupt .It amr%d: can't allocate parent DMA tag .It amr%d: can't allocate buffer DMA tag .It amr%d: can't allocate scatter/gather DMA tag .It amr%d: can't allocate s/g table .It amr%d: can't allocate mailbox tag .It amr%d: can't allocate mailbox memory .Pp A resource allocation error occurred while initialising the driver; initialisation has failed and the driver will not attach to this controller. .It amr%d: can't obtain configuration data from controller .It amr%d: can't obtain product data from controller .Pp The driver was unable to obtain vital configuration data from the controller. Initialisation has failed and the driver will not attach to this controller. .It amr%d: can't establish configuration hook .It amr%d: can't scan controller for drives .Pp The scan for logical drives managed by the controller failed. No drives will be attached. .It amr%d: device_add_child failed .It amr%d: bus_generic_attach returned %d .Pp Creation of the logical drive instances failed; attachment of one or more logical drives may have been aborted. .It amr%d: flushing cache... .Pp The controller cache is being flushed prior to shutdown or detach. .El .Ss Operational diagnostics .Bl -diag .It amr%d: I/O beyond end of unit (%u,%d > %u) .Pp A partitioning error or disk corruption has caused an I/O request beyond the end of the logical drive. This may also occur if FlexRAID Virtual Sizing is enabled and an I/O operation is attempted on a portion of the virtual drive beyond the actual capacity available. .It amr%d: polled command timeout .Pp An initialisation command timed out. The initialisation process may fail as a result. .It amr%d: bad slot %d completed .Pp The controller reported completion of a command that the driver did not issue. This may result in data corruption, and suggests a hardware or firmware problem with the system or controller. .It amr%d: I/O error - %x .Pp An I/O error has occurred. .El .Sh SEE ALSO .Xr cd 4 , .Xr da 4 , .Xr mfi 4 , .Xr sa 4 , .Xr scsi 4 .Sh AUTHORS .An -nosplit The .Nm driver was written by .An Mike Smith Aq msmith@FreeBSD.org . .Pp This manual page was written by .An Mike Smith Aq msmith@FreeBSD.org and .An Jeroen Ruigrok van der Werven Aq asmodai@FreeBSD.org .