| Current Path : /compat/linux/proc/68247/root/usr/src/usr.sbin/sicontrol/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //compat/linux/proc/68247/root/usr/src/usr.sbin/sicontrol/sicontrol.8 |
.\" $FreeBSD: release/9.1.0/usr.sbin/sicontrol/sicontrol.8 179668 2008-06-09 08:43:27Z ed $ .\" .Dd September 26, 1995 .Dt SICONTROL 8 .Os .Sh NAME .Nm sicontrol .Nd Specialix SI/XIO driver configuration and debugging .Sh SYNOPSIS .Nm device .Ar command Op Ar param ... .Sh DESCRIPTION The .Nm utility is used to configure and monitor the SI/XIO device driver. .Pp The .Nm utility operates on the specified .Ar device to indicate which port is to be used. .Pp The special .Ar device string `-' is used to indicate the global driver settings instead. .Pp A .Pa /dev/ is included if necessary. .Pp The following commands are used for the global settings and should be specified with the '-' device name: .Bl -tag -width 4n .It Cm int_throttle Op Cm value Configure the `aggregate interrupt throttle value'. The maximum number of host adapter interrupts per second is determined by: .Pp .Ar "controller CPU clock / (8 * int_throttle)" .Pp The default value at boot time is 25000. The host adapter cpu clock is 25MHz. This gives a maximum interrupt rate of about 125 interrupts per second. .Pp Lowering this value will increase the rate in which the host adapter can interrupt the operating system for attention. .\" .It Cm rxint_throttle Op Cm value Configure the receiver interrupt throttle value. The default value of 4 at boot time allows an interrupt rate of approximately 25. .Pp Lowering this value will increase the rate in which the host adapter can interrupt the operating system to empty the receiver fifos. .\" .It Cm nport Return the number of ports under the control of the device driver. .El .Pp The following commands are used for the individual ports and should be specified with a device name from .Pa /dev : .Bl -tag -width 4n .It Cm mstate Show the current incoming modem control signals. .It Cm ccbstat Show the current "ccb" structure for the specified port. This is not of much use outside of debugging the driver and determining why a port is wedged. .El .Sh FILES .Bl -tag -width /dev/si_control -compact .It Pa /dev/si_control global driver control file for use by .Nm .It Pa /dev/ttyA* terminal control ports .It Pa /dev/ttyiA* initial termios state devices, for use by .Xr stty 1 .It Pa /dev/ttylA* locked termios state devices, for use by .Xr stty 1 .El .Sh DIAGNOSTICS Generally self explanatory..... .Sh SEE ALSO .Xr stty 1 , .Xr si 4 , .Xr termios 4 , .Xr tty 4 , .Xr comcontrol 8 .Sh HISTORY The .Nm utility is loosely based on a utility called .Nm siconfig which was written by .An Andy Rutter Aq andy@acronym.co.uk .Pp Specialix International do not support this device driver in any way. .Sh AUTHORS .An Peter Wemm Aq peter@FreeBSD.org .Sh BUGS Bound to be many... :-)