config root man

Current Path : /compat/linux/proc/self/root/usr/share/misc/

FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64
Upload File :
Current File : //compat/linux/proc/self/root/usr/share/misc/scsi_modes

# SCSI mode page data base.

# Copyright (c) 1995 HD Associates
# Copyright (c) 2001 The FreeBSD Project
# (contact: dufault@hda.com)
# All rights reserved.
# 
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
# 1. Redistributions of source code must retain the above copyright
#    notice, this list of conditions and the following disclaimer.
# 2. Redistributions in binary form must reproduce the above copyright
#    notice, this list of conditions and the following disclaimer in the
#    documentation and/or other materials provided with the distribution.
# 3. The name of HD Associates
#    may not be used to endorse or promote products derived from this software
#    without specific prior written permission.
# 
# THIS SOFTWARE IS PROVIDED BY HD ASSOCIATES ``AS IS'' AND
# ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
# IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
# ARE DISCLAIMED.  IN NO EVENT SHALL HD ASSOCIATES BE LIABLE
# FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
# DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
# OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
# HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
# LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
# OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
# SUCH DAMAGE.
#
# $FreeBSD: release/9.1.0/share/misc/scsi_modes 234638 2012-04-24 07:27:56Z mav $
#
# The ordering is alphabetical by page name, as it appears in the SCSI spec.

# 'i' is a byte-sized integral types, followed by a field width of 
#  1 through 4 (1 to 4 bytes).
#
# 'b' is a bit-sized integral type
# 't' is a bitfield type- followed by a bit field width
#
# 'c' values are character arrays
# 'z' values are null-padded strings
#
#
# '*' suppresses assignment (for 'seeking').
# Bitfields are MSB to LSB.


# ALL DEVICE TYPES

0x0a "Control Mode Page" {
	{TST} t3
	{TMF_ONLY} t1
	{DPICZ} t1
	{D_SENSE} t1
	{GLTSD} t1
	{RLEC} t1
	{Queue Algorithm Modifier} t4
	{NUAR} t1
	{QErr} t2
	{DQue} t1
	{EECA} t1
	{RAC} t1
	{UA_INTLCK_CTRL} t2
	{SWP} t1
	{RAENP} t1
	{UAAENP} t1
	{EAENP} t1
	{ATO} t1
	{TAS} t1
	{ATMPE} t1
	{RWWP} t1
	{Reserved} *t1
	{Autoload Mode} t3
	{Ready AEN Holdoff Period} i2
	{Busy Timeout Period} i2
	{Extended Self-Test Completion Time} i2
}

0x02 "Disconnect-Reconnect Page" {
	{Buffer Full Ratio} i1
	{Buffer Empty Ratio} i1
	{Bus Inactivity Limit} i2
	{Disconnect Time Limit} i2
	{Connect Time Limit} i2
	{Maximum Burst Size} i2
	{Reserved} *t6
	{DTDC} t2
	{Reserved} *i1
	{Reserved} *i1
	{Reserved} *i1
}

0x15 "Extended Page";

0x16 "Extended Device-Type Specific Page";

0x1c "Informational Exceptions Control Page" {
	{PERF} t1
	{Reserved} *t1
	{EBF} t1
	{EWasc} t1
	{DExcpt} t1
	{TEST} t1
	{EBACKERR} t1
	{LogErr} t1
	{Reserved} *t4
	{MRIE} b4
	{Interval Timer} i4
	{Report Count} i4
}

0x09 "Peripheral Device Page" {
	{Interface Identifier} i2
	{Reserved} *i1
	{Reserved} *i1
	{Reserved} *i1
	{Reserved} *i1
}

0x1a "Power Condition Page" {
	{Reserved} *i1
	{Reserved} *t6
	{Idle} t1
	{Standby} t1
	{Idle Condition Timer} i4
	{Standby Condition Timer} i4
}

0x18 "Protocol-Specific LUN Page";

0x19 "Protocol-Specific Port Page";

# DIRECT ACCESS DEVICES
0x08 "Caching Page" {
	{IC} t1
	{ABPF} t1
	{CAP} t1
	{DISC} t1
	{SIZE} t1
	{WCE} t1
	{MF} t1
	{RCD} t1
	{Demand Retention Priority} t4
	{Write Retention Priority} t4
	{Disable Pre-fetch Transfer Length} i2
	{Minimum Pre-fetch} i2
	{Maximum Pre-fetch} i2
	{Maximum Pre-fetch Ceiling} i2
}

0x05 "Flexible Disk Page" {
	{Transfer rate} i2
	{Number of heads} i1
	{Sectors per track} i1
	{Data bytes per sector} i2
	{Number of cylinders} i2
	{Starting cylinder-write precompensation} i2
	{Starting cylinder-reduced write current} i2
	{Drive step rate} i2
	{Drive step pulse width} i1
	{Head settle delay} i2
	{Motor on delay} i1
	{Motor off delay} i1
	{TRDY} t1
	{SSN} t1
	{MO} t1
	{Reserved} *t5
	{Reserved} *t4
	{SPC} t4
	{Write Compensation} i1
	{Head load delay} i1
	{Head unload delay} i1
	{Pin 34} t4
	{Pin 2} t4
	{Pin 4} t4
	{Pin 1} t4
	{Medium rotation rate} i2
	{Reserved} *i1
	{Reserved} *i1
}

0x03 "Format Device Page" {
	{Tracks per Zone} i2
	{Alternate Sectors per Zone} i2
	{Alternate Tracks per Zone} i2
	{Alternate Tracks per Logical Unit} i2
	{Sectors per Track} i2
	{Data Bytes per Physical Sector} i2
	{Interleave} i2
	{Track Skew Factor} i2
	{Cylinder Skew Factor} i2
	{SSEC} t1
	{HSEC} t1
	{RMB} t1
	{SURF} t1
	{Reserved} *t4
}

0x0b "Medium Types Supported Page" {
	{Reserved} *i1
	{Reserved} *i1
	{Medium type one supported} i1
	{Medium type two supported} i1
	{Medium type three supported} i1
	{Medium type four supported} i1
}

# Notch page (0x0c)
0x0c "Notch and Partition Page";

0x01 "Read-Write Error Recovery Page" {
	{AWRE (Auto Write Reallocation Enbld)} t1
	{ARRE (Auto Read Reallocation Enbld)} t1
	{TB (Transfer Block)} t1
	{RC (Read Continuous)} t1
	{EER (Enable Early Recovery)} t1
	{PER (Post Error)} t1
	{DTE (Disable Transfer on Error)} t1
	{DCR (Disable Correction)} t1
	{Read Retry Count} i1
	{Correction Span} i1
	{Head Offset Count} i1
	{Data Strobe Offset Count} i1
	{Reserved} *i1
	{Write Retry Count} i1
	{Reserved} *i1
	{Recovery Time Limit} i2
}

0x04 "Rigid Disk Drive Geometry Page" {
	{Number of Cylinders} i3
	{Number of Heads} i1
	{Starting Cylinder-Write Precompensation} i3
	{Starting Cylinder-Reduced Write Current} i3
	{Drive Step Rate} i2
	{Landing Zone Cylinder} i3
	{Reserved} *t6
	{RPL} t2
	{Rotational Offset} i1
	{Reserved} *i1
	{Medium Rotation Rate} i2
	{Reserved} *i1
	{Reserved} *i1
}

0x07 "Verify Error Recovery Page" {
	{Reserved} *t4
	{EER} t1
	{PER} t1
	{DTE} t1
	{DCR} t1
	{Verify Retry Count} i1
	{Verify Correction Span} i1
	{Reserved} *i1
	{Reserved} *i1
	{Reserved} *i1
	{Reserved} *i1
	{Reserved} *i1
	{Verify Recovery Time Limit} i2
}

0x0E "CD-ROM Audio Control Parameters Page" {
	{Reserved} *t5
	{Immed} t1
	{SOTC} t1
	{Reserved} *t1
	{Reserved} *i2
	{APRVal} t1
	{Reserved} *t3
	{Format of LBAs / sec.} t4
	{Logical Blocks per Second of Audio Playback} i2
	{Reserved} *t4
	{Output Port 0 Channel Selection} t4
	{Output Port 0 Volume} i1
	{Reserved} *t4
	{Output Port 1 Channel Selection} t4
	{Output Port 1 Volume} i1
	{Reserved} *t4
	{Output Port 2 Channel Selection} t4
	{Output Port 2 Volume} i1
	{Reserved} *t4
	{Output Port 3 Channel Selection} t4
	{Output Port 3 Volume} i1
}

# SEQUENTIAL ACCESS DEVICES
0x10 "Device Configuration Page" {
	{Reserved} *t1
	{Change Active Partition} t1
	{Change Active Format} t1
	{Active Format} t5
	{Active Partition} i1
	{Write Buffer Full Ratio} i1
	{Write Buffer Empty Ratio} i1
	{Write Delay Time} i2
	{Data Buffer Recovery} t1
	{Block Identifiers Support} t1
	{Report Setmarks} t1
	{Automatic Velocity Control} t1
	{Stop on Consecutive Filemarks} t2
	{Recover Buffer Order} t1
	{Report Early-Warning} t1
	{Gap Size} i1
	{EOD Defined} t3
	{Enable EOD Generation} t1
	{Synchronize at Early-Warning} t1
	{Reserved} *t3
	{Buffer Size at Early-Warning} i3
	{Select Data Compression Algorithm} i1
	{Reserved} *t5
	{SCSI-3 Associated Write Protect} t1
	{SCSI-3 Persistent Write Protect} t1
	{SCSI-3 Permanent Write Protect} t1
}

0x0f "Data Compression Page" {
	{Data Compression Enabled} t1
	{Date Compression Capable} t1
	{Reserved} *t6
	{Data Decompression Capable} t1
	{Data Decompression Report on Exception} t2
	{Reserved} *t5
	{Compression Algorithm} i4
	{Decompression Algorithm} i4
	{Reserved} *i4
}

# Removable devices
0x1b "Removable Block Access Capacities Page" {
	{System Floppy Type Device} t1
	{Supports Reporting Format Progress} t1
	{Reserved} *t6
	{Non CD Optical Device} t1
	{Single or Multiple LUN Supported} t1
	{Reserved} *t3
	{Total Logical Units Supported} t3
	{Reserved} *i8
}

# CD-ROM (and CD-R[W]) devices
0x2a "CD capabilities and mechanical status page" {
	{Reserved} *t4
	{Method 2} t1
	{CD-RW Read} t1
	{CD-R Read} t1
	{Reserved} *t4
	{Test Write} t1
	{CD-RW Write} t1
	{CD-R Write} t1
	{Reserved} *t1
	{Multi Session} t1
	{Mode 2 Form 2} t1
	{Mode 2 Form 1} t1
	{Digital Port (2)} t1
	{Digital Port (1)} t1
	{Composite} t1
	{Audio Play} t1
	{Read Bar Code} t1
	{UPC} t1
	{ISRC} t1
	{C2 Pointers are supported} t1
	{R-W De-interleaved & corrected} t1
	{R-W Supported} t1
	{CD-DA Stream is Accurate} t1
	{CD-DA Commands Supported} t1
	{Loading Mechanism Type} t3
	{Reserved} *t1
	{Eject} t1
	{Prevent Jumper} t1
	{Lock State} t1
	{Lock} t1
	{Reserved} *t4
	{S/W Slot Selection} t1
	{Changer Supports Disc Present reporting} t1
	{Separate Channel Mute Supported} t1
	{Separate volume levels per channel} t1
	{Maximum Read Speed Supported (kBps)} i2
	{Number of Volume Leves Supported} i2
	{Buffer Size supported by Drive (KB)} i2
	{Current Read Speed Selected (kBps)} i2
	{Reserved} *i1
	{Reserved} *t2
	{Length} t2
	{LSBF} t1
	{RCK} t1
	{BCK} t1
	{Reserved} *t1
	{Maximum Write Speed Supported (kBps)} i2
	{Current Write Speed Supported (kBps)} i2
};

0x00 "Vendor-Specific";

Man Man