Current Path : /etc/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
Current File : //etc/pccard_ether |
#!/bin/sh - # # $FreeBSD: release/9.1.0/etc/pccard_ether 179961 2008-06-23 20:50:11Z mtm $ # # pccard_ether interfacename [start|stop|restart] # # example: pccard_ether fxp0 start # . /etc/rc.subr . /etc/network.subr name="pccard_ether" start_precmd="checkauto" start_cmd="pccard_ether_start" stop_precmd="checkauto" stop_cmd="pccard_ether_stop" restart_precmd="checkauto" restart_cmd="pccard_ether_restart" setup_routes() { # Add default route into $static_routes case ${defaultrouter} in [Nn][Oo] | '') ;; *) static_routes="default ${static_routes}" route_default="default ${defaultrouter}" ;; esac # Add private route for this interface into $static_routes eval ifx_routes=\$static_routes_${ifn} if [ -n "${ifx_routes}" ]; then static_routes="${ifx_routes} ${static_routes}" fi # Set up any static routes if specified if [ -n "${static_routes}" ]; then for i in ${static_routes}; do eval route_args=\$route_${i} route add ${route_args} done fi } remove_routes() { # Delete static route if specified eval ifx_routes=\$static_routes_${ifn} if [ -n "${ifx_routes}" ]; then for i in ${ifx_routes}; do eval route_args=\$route_${i} route delete ${route_args} done fi } checkauto() { if [ -z "$rc_force" ]; then # Ignore interfaces with the NOAUTO keyword autoif $ifn || exit 0 fi } pccard_ether_start() { ifexists $ifn || exit 1 if [ -z "$rc_force" ]; then for uif in `ifconfig -ul`; do if [ "${uif}" = "${ifn}" ]; then # Interface is already up, so ignore it. exit 0 fi done fi /etc/rc.d/netif quietstart $ifn # Do route configuration if needed. # XXX: should probably do this by calling rc.d/routing. if [ -n "`ifconfig_getargs $ifn`" ]; then if ! dhcpif $ifn; then setup_routes fi fi # XXX: IPv6 setup should be done in some way. } pccard_ether_stop() { if [ -n "`ifconfig_getargs $ifn`" ]; then if ! dhcpif $ifn; then remove_routes fi fi /etc/rc.d/netif quietstop $ifn # clean ARP table ifexists $ifn && arp -d -i $ifn -a } pccard_ether_restart() { # Hand implemented because the default implementation runs # the equivalent of "$0 start; $0 stop" and this script # doesn't support that syntax pccard_ether_stop pccard_ether_start } ifn=$1 shift if [ -z "$*" ]; then args="start" else args=$* fi load_rc_config pccard_ether run_rc_command $args