| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/drm2/drm2/@/amd64/amd64/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/drm2/drm2/@/amd64/amd64/mpboot.S |
/*- * Copyright (c) 2003 Peter Wemm * All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE * ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF * SUCH DAMAGE. * * $FreeBSD: release/9.1.0/sys/amd64/amd64/mpboot.S 130224 2004-06-08 01:02:52Z peter $ */ #include <machine/asmacros.h> /* miscellaneous asm macros */ #include <machine/specialreg.h> #include "assym.s" .data /* So we can modify it */ .p2align 4,0 .globl mptramp_start mptramp_start: .code16 /* * The AP enters here in response to the startup IPI. * We are in real mode. %cs is the only segment register set. */ cli /* make sure no interrupts */ mov %cs, %ax /* copy %cs to %ds. Remember these */ mov %ax, %ds /* are offsets rather than selectors */ mov %ax, %ss /* * Find relocation base and patch the gdt descript and ljmp targets */ xorl %ebx,%ebx mov %cs, %bx sall $4, %ebx /* %ebx is now our relocation base */ orl %ebx, lgdt_desc-mptramp_start+2 orl %ebx, jmp_32-mptramp_start+2 orl %ebx, jmp_64-mptramp_start+1 /* * Load the descriptor table pointer. We'll need it when running * in 16 bit protected mode. */ lgdt lgdt_desc-mptramp_start /* Enable protected mode */ movl $CR0_PE, %eax mov %eax, %cr0 /* * Now execute a far jump to turn on protected mode. This * causes the segment registers to turn into selectors and causes * %cs to be loaded from the gdt. * * The following instruction is: * ljmpl $bootcode-gdt, $protmode-mptramp_start * but gas cannot assemble that. And besides, we patch the targets * in early startup and its a little clearer what we are patching. */ jmp_32: .byte 0x66 /* size override to 32 bits */ .byte 0xea /* opcode for far jump */ .long protmode-mptramp_start /* offset in segment */ .word bootcode-gdt /* index in gdt for 32 bit code */ /* * At this point, we are running in 32 bit legacy protected mode. */ .code32 protmode: mov $bootdata-gdt, %eax mov %ax, %ds /* Turn on the PAE, PSE and PGE bits for when paging is enabled */ mov %cr4, %eax orl $(CR4_PAE | CR4_PSE), %eax mov %eax, %cr4 /* * Enable EFER.LME so that we get long mode when all the prereqs are * in place. In this case, it turns on when CR0_PG is finally enabled. * Pick up a few other EFER bits that we'll use need we're here. */ movl $MSR_EFER, %ecx rdmsr orl $EFER_LME | EFER_SCE, %eax wrmsr /* * Point to the embedded page tables for startup. Note that this * only gets accessed after we're actually in 64 bit mode, however * we can only set the bottom 32 bits of %cr3 in this state. This * means we are required to use a temporary page table that is below * the 4GB limit. %ebx is still our relocation base. We could just * subtract 3 * PAGE_SIZE, but that would be too easy. */ leal mptramp_pagetables-mptramp_start(%ebx),%eax movl (%eax), %eax mov %eax, %cr3 /* * Finally, switch to long bit mode by enabling paging. We have * to be very careful here because all the segmentation disappears * out from underneath us. The spec says we can depend on the * subsequent pipelined branch to execute, but *only if* everthing * is still identity mapped. If any mappings change, the pipeline * will flush. */ mov %cr0, %eax orl $CR0_PG, %eax mov %eax, %cr0 /* * At this point paging is enabled, and we are in "compatability" mode. * We do another far jump to reload %cs with the 64 bit selector. * %cr3 points to a 4-level page table page. * We cannot yet jump all the way to the kernel because we can only * specify a 32 bit linear address. So, yet another trampoline. * * The following instruction is: * ljmp $kernelcode-gdt, $tramp_64-mptramp_start * but gas cannot assemble that. And besides, we patch the targets * in early startup and its a little clearer what we are patching. */ jmp_64: .byte 0xea /* opcode for far jump */ .long tramp_64-mptramp_start /* offset in segment */ .word kernelcode-gdt /* index in gdt for 64 bit code */ /* * Yeehar! We're running in 64 bit mode! We can mostly ignore our * segment registers, and get on with it. * Note that we are running at the correct virtual address, but with * a 1:1 1GB mirrored mapping over entire address space. We had better * switch to a real %cr3 promptly so that we can get to the direct map * space. Remember that jmp is relative and that we've been relocated, * so use an indirect jump. */ .code64 tramp_64: movabsq $entry_64,%rax /* 64 bit immediate load */ jmp *%rax .p2align 4,0 gdt: /* * All segment descriptor tables start with a null descriptor */ .long 0x00000000 .long 0x00000000 /* * This is the 64 bit long mode code descriptor. There is no * 64 bit data descriptor. */ kernelcode: .long 0x00000000 .long 0x00209800 /* * This is the descriptor for the 32 bit boot code. * %cs: +A, +R, -C, DPL=0, +P, +D, +G * Accessed, Readable, Present, 32 bit, 4G granularity */ bootcode: .long 0x0000ffff .long 0x00cf9b00 /* * This is the descriptor for the 32 bit boot data. * We load it into %ds and %ss. The bits for each selector * are interpreted slightly differently. * %ds: +A, +W, -E, DPL=0, +P, +D, +G * %ss: +A, +W, -E, DPL=0, +P, +B, +G * Accessed, Writeable, Expand up, Present, 32 bit, 4GB * For %ds, +D means 'default operand size is 32 bit'. * For %ss, +B means the stack register is %esp rather than %sp. */ bootdata: .long 0x0000ffff .long 0x00cf9300 gdtend: /* * The address of our page table pages that the boot code * uses to trampoline up to kernel address space. */ .globl mptramp_pagetables mptramp_pagetables: .long 0 /* * The pseudo descriptor for lgdt to use. */ lgdt_desc: .word gdtend-gdt /* Length */ .long gdt-mptramp_start /* Offset plus %ds << 4 */ .globl mptramp_end mptramp_end: /* * From here on down is executed in the kernel .text section. * * Load a real %cr3 that has all the direct map stuff and switches * off the 1GB replicated mirror. Load a stack pointer and jump * into AP startup code in C. */ .text .code64 .p2align 4,0 entry_64: movq KPML4phys, %rax movq %rax, %cr3 movq bootSTK, %rsp jmp init_secondary