| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/dtrace/profile/@/dev/mii/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/dtrace/profile/@/dev/mii/nsphyterreg.h |
/* $NetBSD: nsphyterreg.h,v 1.4 2005/12/11 12:22:42 christos Exp $ */ /*- * Copyright (c) 1999, 2001 The NetBSD Foundation, Inc. * All rights reserved. * * This code is derived from software contributed to The NetBSD Foundation * by Jason R. Thorpe of the Numerical Aerospace Simulation Facility, * NASA Ames Research Center. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE * POSSIBILITY OF SUCH DAMAGE. * * $FreeBSD: release/9.1.0/sys/dev/mii/nsphyterreg.h 204646 2010-03-03 17:55:51Z joel $ */ #ifndef _DEV_MII_NSPHYTERREG_H_ #define _DEV_MII_NSPHYTERREG_H_ /* * DP83843 registers; We also have the MacPHYTER (DP83815) internal * PHY register definitions here, since the two are, for our purposes, * compatible. */ #define MII_NSPHYTER_PHYSTS 0x10 /* PHY status */ #define PHYSTS_REL 0x8000 /* receive error latch */ #define PHYSTS_CIML 0x4000 /* CIM latch */ #define PHYSTS_FCSL 0x2000 /* false carrier sense latch */ #define PHYSTS_DEVRDY 0x0800 /* device ready */ #define PHYSTS_PGRX 0x0400 /* page received */ #define PHYSTS_ANEGEN 0x0200 /* autoneg. enabled */ #define PHYSTS_MIIINTR 0x0100 /* MII interrupt */ #define PHYSTS_REMFAULT 0x0080 /* remote fault */ #define PHYSTS_JABBER 0x0040 /* jabber detect */ #define PHYSTS_NWAYCOMP 0x0020 /* NWAY complete */ #define PHYSTS_RESETSTAT 0x0010 /* reset status */ #define PHYSTS_LOOPBACK 0x0008 /* loopback status */ #define PHYSTS_DUPLEX 0x0004 /* full duplex */ #define PHYSTS_SPEED10 0x0002 /* speed == 10Mb/s */ #define PHYSTS_LINK 0x0001 /* link up */ /* Below are the MacPHYTER bits that are different. */ #define PHYSTS_MP_REL 0x2000 /* receive error latch */ #define PHYSTS_MP_POLARITY 0x1000 /* polarity inverted */ #define PHYSTS_MP_FCSL 0x0800 /* false carrier sense latch */ #define PHYSTS_MP_SIGNAL 0x0400 /* signal detect */ #define PHYSTS_MP_DESCRLK 0x0200 /* de-scrambler lock */ #define PHYSTS_MP_PGRX 0x0100 /* page received */ #define PHYSTS_MP_MIIINTR 0x0080 /* MII interrupt */ #define PHYSTS_MP_REMFAULT 0x0040 /* remote fault */ #define PHYSTS_MP_JABBER 0x0020 /* jabber detect */ #define PHYSTS_MP_NWAYCOMP 0x0010 /* NWAY complete */ #define MII_NSPHYTER_MIPSCR 0x11 /* MII interrupt PHY specific control */ #define MIPSCR_INTEN 0x0002 /* interrupt enable */ #define MIPSCR_TINT 0x0001 /* test interrupt */ #define MII_NSPHYTER_MIPGSR 0x12 /* MII interrupt PHY generic status */ #define MIPGSR_MINT 0x8000 /* MII interrupt pending */ /* The bits below are MacPHYTER only. */ #define MIPGSR_MSK_LINK 0x4000 /* mask link status event */ #define MIPGSR_MSK_JAB 0x2000 /* mask jabber event */ #define MIPGSR_MSK_RF 0x1000 /* mask remote fault event */ #define MIPGSR_MSK_ANC 0x0800 /* mask auto-neg complete event */ #define MIPGSR_MSK_FHF 0x0400 /* mask false carrier half full event */ #define MIPGSR_MSK_RHF 0x0200 /* mask RX error half full event */ #define MII_NSPHYTER_DCR 0x13 /* Disconnect counter */ #define MII_NSPHYTER_FCSCR 0x14 /* False carrier sense counter */ #define MII_NSPHYTER_RECR 0x15 /* Receive error counter */ #define MII_NSPHYTER_PCSR 0x16 /* PCS configuration and status */ #define PCSR_SINGLE_SD 0x8000 /* single-ended SD mode */ #define PCSR_FEFI_EN 0x4000 /* far end fault indication mode */ #define PCSR_DESCR_TO_RST 0x2000 /* reset descrambler timeout counter */ #define PCSR_DESCR_TO_SEL 0x1000 /* descrambler timer mode */ #define PCSR_DESCR_TO_DIS 0x0800 /* descrambler timer disable */ #define PCSR_LD_SCR_SD 0x0400 /* load scrambler seed */ #define PCSR_TX_QUIET 0x0200 /* 100Mb/s transmit true quiet mode */ #define PCSR_TX_PATTERN 0x0180 /* 100Mb/s transmit test pattern */ #define PCSR_F_LINK_100 0x0040 /* force good link in 100Mb/s */ #define PCSR_CIM_DIS 0x0020 /* carrier integrity monitor disable */ #define PCSR_CIM_STATUS 0x0010 /* carrier integrity monitor status */ #define PCSR_CODE_ERR 0x0008 /* code errors */ #define PCSR_PME_ERR 0x0004 /* premature end errors */ #define PCSR_LINK_ERR 0x0002 /* link errors */ #define PCSR_PKT_ERR 0x0001 /* packet errors */ /* Below are the MacPHYTER bits that are different. */ #define PCSR_MP_BYP_4B5B 0x1000 /* bypass encoder */ #define PCSR_MP_FREE_CLK 0x0800 /* free funning RX clock */ #define PCSR_MP_TQ_EN 0x0400 /* enable True Quiet mode */ #define PCSR_MP_SD_FORCE_B 0x0200 /* force signal detection */ #define PCSR_MP_SD_OPTION 0x0100 /* enhanced signal detection alg. */ #define PCSR_MP_NRZI_BYPASS 0x0004 /* NRZI bypass enabled */ /* The bits below are not on MacPHYTER. */ #define MII_NSPHYTER_LBR 0x17 /* loopback and bypass */ #define LBR_BP_STRETCH 0x4000 /* bypass LED stretching */ #define LBR_BP_4B5B 0x2000 /* bypass encoding/decoding */ #define LBR_BP_SCR 0x1000 /* bypass scrambler/descrambler */ #define LBR_BP_RX 0x0800 /* bypass receive function */ #define LBR_BP_TX 0x0400 /* bypass transmit function */ #define LBR_100_DP_CTL 0x0380 /* 100Mb/s data patch control */ #define LBR_TW_LBEN 0x0020 /* TWISTER loopback enable */ #define LBR_10_ENDEC_LB 0x0010 /* 10Mb/s ENDEC loopback */ /* The bits below are not on MacPHYTER. */ #define MII_NSPHYTER_10BTSCR 0x18 /* 10baseT status and control */ #define BTSCR_AUI_TPI 0x2000 /* TREX operating mode */ #define BTSCR_RX_SERIAL 0x1000 /* 10baseT RX serial mode */ #define BTSCR_TX_SERIAL 0x0800 /* 10baseT TX serial mode */ #define BTSCR_POL_DS 0x0400 /* polarity detection and correction disable */ #define BTSCR_AUTOSW_EN 0x0200 /* AUI/TPI autoswitch */ #define BTSCR_LP_DS 0x0100 /* link pulse disable */ #define BTSCR_HB_DS 0x0080 /* heartbeat disabled */ #define BTSCR_LS_SEL 0x0040 /* low squelch select */ #define BTSCR_AUI_SEL 0x0020 /* AUI select */ #define BTSCR_JAB_DS 0x0010 /* jabber disable */ #define BTSCR_THIN_SEL 0x0008 /* thin ethernet select */ #define BTSCR_TX_FILT_DS 0x0004 /* TPI receive filter disable */ #define MII_NSPHYTER_PHYCTRL 0x19 /* PHY control */ #define PHYCTRL_TW_EQSEL 0x3000 /* TWISTER e.q. select */ #define PHYCTRL_BLW_DS 0x0800 /* TWISTER base line wander disable */ #define PHYCTRL_REPEATER 0x0200 /* repeater mode */ #define PHYCTRL_LED_TXRX_MODE 0x0180 /* LED TX/RX mode */ #define PHYCTRL_LED_DUP_MODE 0x0040 /* LED DUP mode */ #define PHYCTRL_FX_EN 0x0020 /* Fiber mode enable */ #define PHYCTRL_PHYADDR 0x001f /* PHY address */ /* Below are the MacPHYTER bits that are different. */ #define PHYCRTL_MP_PSR_15 0x0800 /* BIST sequence select */ #define PHYCTRL_MP_BIST_STAT 0x0400 /* BIST passed */ #define PHYCTRL_MP_BIST_START 0x0200 /* start BIST */ #define PHYCTRL_MP_BP_STRETCH 0x0100 /* bypass LED stretching */ #define PHYCTRL_MP_PAUSE_STS 0x0080 /* pause status */ /* The bits below are MacPHYTER only. */ #define MII_MACPHYTER_TBTCTL 0x1a /* 10baseT Control */ #define TBTCTL_LOOPBACK_10_DIS 0x0100 /* loopback 10Mb/s disable */ #define TBTCTL_LP_DIS 0x0080 /* link pulse disable */ #define TBTCTL_FORCE_LINK_10 0x0040 /* force 10Mb/s link good */ #define TBTCTL_FORCE_POL_COR 0x0020 /* force polarity correction */ #define TBTCTL_INV_POLARITY 0x0010 /* inverted polarity */ #define TBTCTL_AUTOPOL_DIS 0x0008 /* auto-polarity disable */ #define TBTCTL_HEARTBEAT_DIS 0x0002 /* heartbeat disable */ #define TBTCTL_JABBER_DIS 0x0001 /* jabber disable */ #endif /* _DEV_MII_NSPHYTERREG_H_ */