config root man

/*
 * Copyright (c) 2002-2008 Sam Leffler, Errno Consulting
 * Copyright (c) 2002-2008 Atheros Communications, Inc.
 *
 * Permission to use, copy, modify, and/or distribute this software for any
 * purpose with or without fee is hereby granted, provided that the above
 * copyright notice and this permission notice appear in all copies.
 *
 * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
 * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
 * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
 * ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
 * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
 * ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
 * OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
 *
 * $FreeBSD: release/9.1.0/sys/dev/ath/ath_hal/ar5312/ar5312_misc.c 204644 2010-03-03 17:32:32Z rpaulo $
 */
#include "opt_ah.h"

#ifdef AH_SUPPORT_AR5312

#include "ah.h"
#include "ah_internal.h"
#include "ah_devid.h"

#include "ar5312/ar5312.h"
#include "ar5312/ar5312reg.h"
#include "ar5312/ar5312phy.h"

#define	AR_NUM_GPIO	6		/* 6 GPIO pins */
#define	AR_GPIOD_MASK	0x0000002F	/* GPIO data reg r/w mask */

/*
 * Change the LED blinking pattern to correspond to the connectivity
 */
void
ar5312SetLedState(struct ath_hal *ah, HAL_LED_STATE state)
{
	uint32_t val;
	uint32_t resOffset = (AR5312_RSTIMER_BASE - ((uint32_t) ah->ah_sh));
    if(IS_2316(ah)) return; /* not yet */
	val = SM(AR5312_PCICFG_LEDSEL0, AR5312_PCICFG_LEDSEL) |
		SM(AR5312_PCICFG_LEDMOD0, AR5312_PCICFG_LEDMODE) |
		2;
	OS_REG_WRITE(ah, resOffset+AR5312_PCICFG,
		(OS_REG_READ(ah, AR5312_PCICFG) &~
		 (AR5312_PCICFG_LEDSEL | AR5312_PCICFG_LEDMODE |
		  AR5312_PCICFG_LEDSBR))
		     | val);
}

/*
 * Detect if our wireless mac is present. 
 */
HAL_BOOL
ar5312DetectCardPresent(struct ath_hal *ah)
{
	uint16_t macVersion, macRev;
	uint32_t v;

	/*
	 * Read the Silicon Revision register and compare that
	 * to what we read at attach time.  If the same, we say
	 * a card/device is present.
	 */
#if (AH_SUPPORT_2316 || AH_SUPPORT_2317)
    if(IS_5315(ah))
    {
		v = (OS_REG_READ(ah,
                         (AR5315_RSTIMER_BASE-((uint32_t) ah->ah_sh)) + AR5315_WREV))
			& AR_SREV_ID;
		macVersion = v >> AR_SREV_ID_S;
		macRev = v & AR_SREV_REVISION;
		return (AH_PRIVATE(ah)->ah_macVersion == macVersion &&
				AH_PRIVATE(ah)->ah_macRev == macRev);
    }
    else
#endif
    {
		v = (OS_REG_READ(ah,
                         (AR5312_RSTIMER_BASE-((uint32_t) ah->ah_sh)) + AR5312_WREV))
			& AR_SREV_ID;
		macVersion = v >> AR_SREV_ID_S;
		macRev = v & AR_SREV_REVISION;
		return (AH_PRIVATE(ah)->ah_macVersion == macVersion &&
				AH_PRIVATE(ah)->ah_macRev == macRev);
    }
}

/*
 * If 32KHz clock exists, use it to lower power consumption during sleep
 *
 * Note: If clock is set to 32 KHz, delays on accessing certain
 *       baseband registers (27-31, 124-127) are required.
 */
void
ar5312SetupClock(struct ath_hal *ah, HAL_OPMODE opmode)
{
	if (ar5212Use32KHzclock(ah, opmode)) {
		/*
		 * Enable clocks to be turned OFF in BB during sleep
		 * and also enable turning OFF 32MHz/40MHz Refclk
		 * from A2.
		 */
		OS_REG_WRITE(ah, AR_PHY_SLEEP_CTR_CONTROL, 0x1f);
		OS_REG_WRITE(ah, AR_PHY_SLEEP_CTR_LIMIT,   0x0d);
		OS_REG_WRITE(ah, AR_PHY_SLEEP_SCAL,        0x0c);
		OS_REG_WRITE(ah, AR_PHY_M_SLEEP,           0x03);
		OS_REG_WRITE(ah, AR_PHY_REFCLKDLY,         0x05);
		OS_REG_WRITE(ah, AR_PHY_REFCLKPD,
		    IS_RAD5112_ANY(ah) ? 0x14 : 0x18);

		OS_REG_RMW_FIELD(ah, AR_USEC, AR_USEC_USEC32, 1);
		OS_REG_WRITE(ah, AR_TSF_PARM, 61);	/* 32 KHz TSF incr */

	} else {
		OS_REG_WRITE(ah, AR_TSF_PARM, 1);	/* 32 MHz TSF incr */
		OS_REG_RMW_FIELD(ah, AR_USEC, AR_USEC_USEC32,
		    IS_RAD5112_ANY(ah) ? 39 : 31);

		OS_REG_WRITE(ah, AR_PHY_SLEEP_CTR_CONTROL, 0x1f);
		OS_REG_WRITE(ah, AR_PHY_SLEEP_CTR_LIMIT,   0x7f);

		if (IS_5312_2_X(ah)) {
			/* Set ADC/DAC select values */
			OS_REG_WRITE(ah, AR_PHY_SLEEP_SCAL,        0x04);
		} else {
			OS_REG_WRITE(ah, AR_PHY_SLEEP_SCAL,        0x0e);
			OS_REG_WRITE(ah, AR_PHY_M_SLEEP,           0x0c);
			OS_REG_WRITE(ah, AR_PHY_REFCLKDLY,         0xff);
			OS_REG_WRITE(ah, AR_PHY_REFCLKPD,
			    IS_RAD5112_ANY(ah) ? 0x14 : 0x18);
		}
	}
}

/*
 * If 32KHz clock exists, turn it off and turn back on the 32Mhz
 */
void
ar5312RestoreClock(struct ath_hal *ah, HAL_OPMODE opmode)
{
	if (ar5212Use32KHzclock(ah, opmode)) {
		/* # Set sleep clock rate back to 32 MHz. */
		OS_REG_WRITE(ah, AR_TSF_PARM, 1);	/* 32 MHz TSF incr */
		OS_REG_RMW_FIELD(ah, AR_USEC, AR_USEC_USEC32,
		    IS_RAD5112_ANY(ah) ? 39 : 31);

		/*
		 * Restore BB registers to power-on defaults
		 */
		OS_REG_WRITE(ah, AR_PHY_SLEEP_CTR_CONTROL, 0x1f);
		OS_REG_WRITE(ah, AR_PHY_SLEEP_CTR_LIMIT,   0x7f);
		if (IS_5312_2_X(ah)) {
			/* Set ADC/DAC select values */
			OS_REG_WRITE(ah, AR_PHY_SLEEP_SCAL,        0x04);
		} else {
			OS_REG_WRITE(ah, AR_PHY_SLEEP_SCAL,        0x0e);
			OS_REG_WRITE(ah, AR_PHY_M_SLEEP,           0x0c);
			OS_REG_WRITE(ah, AR_PHY_REFCLKDLY,         0xff);
			OS_REG_WRITE(ah, AR_PHY_REFCLKPD,
			    IS_RAD5112_ANY(ah) ? 0x14 : 0x18);
		}
	}
}

#endif /* AH_SUPPORT_AR5312 */