| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/libalias/modules/irc/@/contrib/octeon-sdk/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/libalias/modules/irc/@/contrib/octeon-sdk/cvmx-twsi.h |
/***********************license start***************
* Copyright (c) 2003-2010 Cavium Networks (support@cavium.com). All rights
* reserved.
*
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are
* met:
*
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
*
* * Redistributions in binary form must reproduce the above
* copyright notice, this list of conditions and the following
* disclaimer in the documentation and/or other materials provided
* with the distribution.
* * Neither the name of Cavium Networks nor the names of
* its contributors may be used to endorse or promote products
* derived from this software without specific prior written
* permission.
* This Software, including technical data, may be subject to U.S. export control
* laws, including the U.S. Export Administration Act and its associated
* regulations, and may be subject to export or import regulations in other
* countries.
* TO THE MAXIMUM EXTENT PERMITTED BY LAW, THE SOFTWARE IS PROVIDED "AS IS"
* AND WITH ALL FAULTS AND CAVIUM NETWORKS MAKES NO PROMISES, REPRESENTATIONS OR
* WARRANTIES, EITHER EXPRESS, IMPLIED, STATUTORY, OR OTHERWISE, WITH RESPECT TO
* THE SOFTWARE, INCLUDING ITS CONDITION, ITS CONFORMITY TO ANY REPRESENTATION OR
* DESCRIPTION, OR THE EXISTENCE OF ANY LATENT OR PATENT DEFECTS, AND CAVIUM
* SPECIFICALLY DISCLAIMS ALL IMPLIED (IF ANY) WARRANTIES OF TITLE,
* MERCHANTABILITY, NONINFRINGEMENT, FITNESS FOR A PARTICULAR PURPOSE, LACK OF
* VIRUSES, ACCURACY OR COMPLETENESS, QUIET ENJOYMENT, QUIET POSSESSION OR
* CORRESPONDENCE TO DESCRIPTION. THE ENTIRE RISK ARISING OUT OF USE OR
* PERFORMANCE OF THE SOFTWARE LIES WITH YOU.
***********************license end**************************************/
/**
* @file
*
* Interface to the TWSI / I2C bus
*
* Note: Currently on 7 bit device addresses are supported
*
* <hr>$Revision: 49448 $<hr>
*
*/
#ifndef __CVMX_TWSI_H__
#define __CVMX_TWSI_H__
#ifdef __cplusplus
extern "C" {
#endif
/* Extra TWSI Bus Opcodes */
#define TWSI_SLAVE_ADD 0
#define TWSI_DATA 1
#define TWSI_CTL 2
#define TWSI_CLKCTL_STAT 3 /* R=0 selects CLKCTL, R=1 selects STAT */
#define TWSI_STAT 3 /* when R = 1 */
#define TWSI_SLAVE_ADD_EXT 4
#define TWSI_RST 7
/**
* Do a twsi read from a 7 bit device address using an (optional) internal address.
* Up to 8 bytes can be read at a time.
*
* @param twsi_id which Octeon TWSI bus to use
* @param dev_addr Device address (7 bit)
* @param internal_addr
* Internal address. Can be 0, 1 or 2 bytes in width
* @param num_bytes Number of data bytes to read
* @param ia_width_bytes
* Internal address size in bytes (0, 1, or 2)
* @param data Pointer argument where the read data is returned.
*
* @return read data returned in 'data' argument
* Number of bytes read on success
* -1 on failure
*/
int cvmx_twsix_read_ia(int twsi_id, uint8_t dev_addr, uint16_t internal_addr, int num_bytes, int ia_width_bytes, uint64_t *data);
/**
* A convenience wrapper function around cvmx_twsix_read_ia() that
* only supports 8 bit internal addresses.
* Reads up to 7 bytes, and returns both the value read or error
* value in the return value
*
* @param twsi_id which Octeon TWSI bus to use
* @param dev_addr Device address (7 bit only)
* @param internal_addr
* Internal address (8 bit only)
* @param num_bytes Number of bytes to read (0-7)
*
* @return Value read from TWSI on success
* -1 on error
*/
static inline int64_t cvmx_twsix_read_ia8(int twsi_id, uint8_t dev_addr, uint8_t internal_addr, int num_bytes)
{
uint64_t data;
if (num_bytes < 1 || num_bytes > 7)
return -1;
if (cvmx_twsix_read_ia(twsi_id,dev_addr,internal_addr,num_bytes, 1, &data) < 0)
return -1;
return data;
}
/**
* A convenience wrapper function around cvmx_twsix_read_ia() that
* only supports 16 bit internal addresses.
* Reads up to 7 bytes, and returns both the value read or error
* value in the return value
*
* @param twsi_id which Octeon TWSI bus to use
* @param dev_addr Device address (7 bit only)
* @param internal_addr
* Internal address (16 bit only)
* @param num_bytes Number of bytes to read (0-7)
*
* @return Value read from TWSI on success
* -1 on error
*/
static inline int64_t cvmx_twsix_read_ia16(int twsi_id, uint8_t dev_addr, uint16_t internal_addr, int num_bytes)
{
uint64_t data;
if (num_bytes < 1 || num_bytes > 7)
return -1;
if (cvmx_twsix_read_ia(twsi_id, dev_addr, internal_addr, num_bytes, 2, &data) < 0)
return -1;
return data;
}
/**
* Read from a TWSI device (7 bit device address only) without generating any
* internal addresses.
* Read from 1-8 bytes and returns them in the data pointer.
*
* @param twsi_id TWSI interface on Octeon to use
* @param dev_addr TWSI device address (7 bit only)
* @param num_bytes number of bytes to read
* @param data Pointer to data read from TWSI device
*
* @return Number of bytes read on success
* -1 on error
*/
int cvmx_twsix_read(int twsi_id, uint8_t dev_addr, int num_bytes, uint64_t *data);
/**
* Perform a twsi write operation to a 7 bit device address.
*
* Note that many eeprom devices have page restrictions regarding address boundaries
* that can be crossed in one write operation. This is device dependent, and this routine
* does nothing in this regard.
* This command does not generate any internal addressess.
*
* @param twsi_id Octeon TWSI interface to use
* @param dev_addr TWSI device address
* @param num_bytes Number of bytes to write (between 1 and 8 inclusive)
* @param data Data to write
*
* @return 0 on success
* -1 on failure
*/
int cvmx_twsix_write(int twsi_id, uint8_t dev_addr, int num_bytes, uint64_t data);
/**
* Write 1-8 bytes to a TWSI device using an internal address.
*
* @param twsi_id which TWSI interface on Octeon to use
* @param dev_addr TWSI device address (7 bit only)
* @param internal_addr
* TWSI internal address (0, 8, or 16 bits)
* @param num_bytes Number of bytes to write (1-8)
* @param ia_width_bytes
* internal address width, in bytes (0, 1, 2)
* @param data Data to write. Data is written MSB first on the twsi bus, and only the lower
* num_bytes bytes of the argument are valid. (If a 2 byte write is done, only
* the low 2 bytes of the argument is used.
*
* @return Number of bytes read on success,
* -1 on error
*/
int cvmx_twsix_write_ia(int twsi_id, uint8_t dev_addr, uint16_t internal_addr, int num_bytes, int ia_width_bytes, uint64_t data);
/***********************************************************************
** Functions below are deprecated, and not recomended for use.
** They have been superceded by more flexible functions that are
** now provided.
************************************************************************/
/**
* Read 8-bit from a device on the TWSI / I2C bus
*
* @param twsi_id Which TWSI bus to use. CN3XXX, CN58XX, and CN50XX only
* support 0. CN56XX and CN57XX support 0-1.
* @param dev_addr I2C device address (7 bit)
* @param internal_addr
* Internal device address
*
* @return 8-bit data or < 0 in case of error
*/
static inline int cvmx_twsix_read8(int twsi_id, uint8_t dev_addr, uint8_t internal_addr)
{
return cvmx_twsix_read_ia8(twsi_id, dev_addr, internal_addr, 1);
}
/**
* Read 8-bit from a device on the TWSI / I2C bus
*
* Uses current internal address
*
* @param twsi_id Which TWSI bus to use. CN3XXX, CN58XX, and CN50XX only
* support 0. CN56XX and CN57XX support 0-1.
* @param dev_addr I2C device address (7 bit)
*
* @return 8-bit value or < 0 in case of error
*/
static inline int cvmx_twsix_read8_cur_addr(int twsi_id, uint8_t dev_addr)
{
uint64_t data;
if (cvmx_twsix_read(twsi_id,dev_addr, 1, &data) < 0)
return -1;
return(data & 0xff);
}
/**
* Write 8-bit to a device on the TWSI / I2C bus
*
* @param twsi_id Which TWSI bus to use. CN3XXX, CN58XX, and CN50XX only
* support 0. CN56XX and CN57XX support 0-1.
* @param dev_addr I2C device address (7 bit)
* @param internal_addr
* Internal device address
* @param data Data to be written
*
* @return 0 on success and < 0 in case of error
*/
static inline int cvmx_twsix_write8(int twsi_id, uint8_t dev_addr, uint8_t internal_addr, uint8_t data)
{
if (cvmx_twsix_write_ia(twsi_id,dev_addr,internal_addr, 1, 1,data) < 0)
return -1;
return 0;
}
/**
* Read 8-bit from a device on the TWSI / I2C bus zero.
*
* This function is for compatibility with SDK 1.6.0 and
* before which only supported a single TWSI bus.
*
* @param dev_addr I2C device address (7 bit)
* @param internal_addr
* Internal device address
*
* @return 8-bit data or < 0 in case of error
*/
static inline int cvmx_twsi_read8(uint8_t dev_addr, uint8_t internal_addr)
{
return cvmx_twsix_read8(0, dev_addr, internal_addr);
}
/**
* Read 8-bit from a device on the TWSI / I2C bus zero.
*
* Uses current internal address
*
* This function is for compatibility with SDK 1.6.0 and
* before which only supported a single TWSI bus.
*
* @param dev_addr I2C device address (7 bit)
*
* @return 8-bit value or < 0 in case of error
*/
static inline int cvmx_twsi_read8_cur_addr(uint8_t dev_addr)
{
return cvmx_twsix_read8_cur_addr(0, dev_addr);
}
/**
* Write 8-bit to a device on the TWSI / I2C bus zero.
* This function is for compatibility with SDK 1.6.0 and
* before which only supported a single TWSI bus.
*
* @param dev_addr I2C device address (7 bit)
* @param internal_addr
* Internal device address
* @param data Data to be written
*
* @return 0 on success and < 0 in case of error
*/
static inline int cvmx_twsi_write8(uint8_t dev_addr, uint8_t internal_addr, uint8_t data)
{
return cvmx_twsix_write8(0, dev_addr, internal_addr, data);
}
#ifdef __cplusplus
}
#endif
#endif /* __CVMX_TWSI_H__ */