| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/rc4/@/dev/ata/chipsets/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/rc4/@/dev/ata/chipsets/ata-ite.c |
/*-
* Copyright (c) 1998 - 2008 Søren Schmidt <sos@FreeBSD.org>
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer,
* without modification, immediately at the beginning of the file.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
* OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
* IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
#include <sys/cdefs.h>
__FBSDID("$FreeBSD: release/9.1.0/sys/dev/ata/chipsets/ata-ite.c 237191 2012-06-17 11:16:14Z marius $");
#include "opt_ata.h"
#include <sys/param.h>
#include <sys/module.h>
#include <sys/systm.h>
#include <sys/kernel.h>
#include <sys/ata.h>
#include <sys/bus.h>
#include <sys/endian.h>
#include <sys/malloc.h>
#include <sys/lock.h>
#include <sys/mutex.h>
#include <sys/sema.h>
#include <sys/taskqueue.h>
#include <vm/uma.h>
#include <machine/stdarg.h>
#include <machine/resource.h>
#include <machine/bus.h>
#include <sys/rman.h>
#include <dev/pci/pcivar.h>
#include <dev/pci/pcireg.h>
#include <dev/ata/ata-all.h>
#include <dev/ata/ata-pci.h>
#include <ata_if.h>
/* local prototypes */
static int ata_ite_chipinit(device_t dev);
static int ata_ite_ch_attach(device_t dev);
static int ata_ite_821x_setmode(device_t dev, int target, int mode);
static int ata_ite_8213_setmode(device_t dev, int target, int mode);
/*
* Integrated Technology Express Inc. (ITE) chipset support functions
*/
static int
ata_ite_probe(device_t dev)
{
struct ata_pci_controller *ctlr = device_get_softc(dev);
static const struct ata_chip_id const ids[] =
{{ ATA_IT8213F, 0x00, 0x00, 0x00, ATA_UDMA6, "IT8213F" },
{ ATA_IT8212F, 0x00, 0x00, 0x00, ATA_UDMA6, "IT8212F" },
{ ATA_IT8211F, 0x00, 0x00, 0x00, ATA_UDMA6, "IT8211F" },
{ 0, 0, 0, 0, 0, 0}};
if (pci_get_vendor(dev) != ATA_ITE_ID)
return ENXIO;
if (!(ctlr->chip = ata_match_chip(dev, ids)))
return ENXIO;
ata_set_desc(dev);
ctlr->chipinit = ata_ite_chipinit;
return (BUS_PROBE_DEFAULT);
}
static int
ata_ite_chipinit(device_t dev)
{
struct ata_pci_controller *ctlr = device_get_softc(dev);
if (ata_setup_interrupt(dev, ata_generic_intr))
return ENXIO;
if (ctlr->chip->chipid == ATA_IT8213F) {
/* the ITE 8213F only has one channel */
ctlr->channels = 1;
ctlr->setmode = ata_ite_8213_setmode;
}
else {
/* set PCI mode and 66Mhz reference clock */
pci_write_config(dev, 0x50, pci_read_config(dev, 0x50, 1) & ~0x83, 1);
/* set default active & recover timings */
pci_write_config(dev, 0x54, 0x31, 1);
pci_write_config(dev, 0x56, 0x31, 1);
ctlr->setmode = ata_ite_821x_setmode;
/* No timing restrictions initally. */
ctlr->chipset_data = NULL;
}
ctlr->ch_attach = ata_ite_ch_attach;
return (0);
}
static int
ata_ite_ch_attach(device_t dev)
{
struct ata_channel *ch = device_get_softc(dev);
int error;
error = ata_pci_ch_attach(dev);
ch->flags |= ATA_CHECKS_CABLE;
#ifdef ATA_CAM
ch->flags |= ATA_NO_ATAPI_DMA;
#endif
return (error);
}
static int
ata_ite_821x_setmode(device_t dev, int target, int mode)
{
device_t parent = device_get_parent(dev);
struct ata_pci_controller *ctlr = device_get_softc(parent);
struct ata_channel *ch = device_get_softc(dev);
int devno = (ch->unit << 1) + target;
int piomode;
uint8_t *timings = (uint8_t*)(&ctlr->chipset_data);
static const uint8_t udmatiming[] =
{ 0x44, 0x42, 0x31, 0x21, 0x11, 0xa2, 0x91 };
static const uint8_t chtiming[] =
{ 0xaa, 0xa3, 0xa1, 0x33, 0x31, 0x88, 0x32, 0x31 };
mode = min(mode, ctlr->chip->max_dma);
/* check the CBLID bits for 80 conductor cable detection */
if (ata_dma_check_80pin && mode > ATA_UDMA2 &&
(pci_read_config(parent, 0x40, 2) &
(ch->unit ? (1<<3) : (1<<2)))) {
ata_print_cable(dev, "controller");
mode = ATA_UDMA2;
}
if (mode >= ATA_UDMA0) {
/* enable UDMA mode */
pci_write_config(parent, 0x50,
pci_read_config(parent, 0x50, 1) &
~(1 << (devno + 3)), 1);
/* set UDMA timing */
pci_write_config(parent,
0x56 + (ch->unit << 2) + target,
udmatiming[mode & ATA_MODE_MASK], 1);
piomode = ATA_PIO4;
} else {
/* disable UDMA mode */
pci_write_config(parent, 0x50,
pci_read_config(parent, 0x50, 1) |
(1 << (devno + 3)), 1);
piomode = mode;
}
timings[devno] = chtiming[ata_mode2idx(piomode)];
/* set active and recover timing (shared between master & slave) */
pci_write_config(parent, 0x54 + (ch->unit << 2),
max(timings[ch->unit << 1], timings[(ch->unit << 1) + 1]), 1);
return (mode);
}
static int
ata_ite_8213_setmode(device_t dev, int target, int mode)
{
device_t parent = device_get_parent(dev);
struct ata_pci_controller *ctlr = device_get_softc(parent);
int piomode;
u_int16_t reg40 = pci_read_config(parent, 0x40, 2);
u_int8_t reg44 = pci_read_config(parent, 0x44, 1);
u_int8_t reg48 = pci_read_config(parent, 0x48, 1);
u_int16_t reg4a = pci_read_config(parent, 0x4a, 2);
u_int16_t reg54 = pci_read_config(parent, 0x54, 2);
u_int16_t mask40 = 0, new40 = 0;
u_int8_t mask44 = 0, new44 = 0;
static const uint8_t timings[] =
{ 0x00, 0x00, 0x10, 0x21, 0x23, 0x00, 0x21, 0x23 };
static const uint8_t utimings[] =
{ 0x00, 0x01, 0x02, 0x01, 0x02, 0x01, 0x02 };
mode = min(mode, ctlr->chip->max_dma);
if (ata_dma_check_80pin && mode > ATA_UDMA2 &&
!(reg54 & (0x10 << target))) {
ata_print_cable(dev, "controller");
mode = ATA_UDMA2;
}
/* Enable/disable UDMA and set timings. */
if (mode >= ATA_UDMA0) {
pci_write_config(parent, 0x48, reg48 | (0x0001 << target), 2);
pci_write_config(parent, 0x4a,
(reg4a & ~(0x3 << (target << 2))) |
(utimings[mode & ATA_MODE_MASK] << (target<<2)), 2);
piomode = ATA_PIO4;
} else {
pci_write_config(parent, 0x48, reg48 & ~(0x0001 << target), 2);
pci_write_config(parent, 0x4a, (reg4a & ~(0x3 << (target << 2))),2);
piomode = mode;
}
/* Set UDMA reference clock (33/66/133MHz). */
reg54 &= ~(0x1001 << target);
if (mode >= ATA_UDMA5)
reg54 |= (0x1000 << target);
else if (mode >= ATA_UDMA3)
reg54 |= (0x1 << target);
pci_write_config(parent, 0x54, reg54, 2);
/* Allow PIO/WDMA timing controls. */
reg40 &= 0xff00;
reg40 |= 0x4033;
/* Set PIO/WDMA timings. */
if (target == 0) {
reg40 |= (ata_atapi(dev, target) ? 0x04 : 0x00);
mask40 = 0x3300;
new40 = timings[ata_mode2idx(piomode)] << 8;
}
else {
reg40 |= (ata_atapi(dev, target) ? 0x40 : 0x00);
mask44 = 0x0f;
new44 = ((timings[ata_mode2idx(piomode)] & 0x30) >> 2) |
(timings[ata_mode2idx(piomode)] & 0x03);
}
pci_write_config(parent, 0x40, (reg40 & ~mask40) | new40, 4);
pci_write_config(parent, 0x44, (reg44 & ~mask44) | new44, 1);
return (mode);
}
ATA_DECLARE_DRIVER(ata_ite);