| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/s3/@/amd64/compile/hs32/modules/usr/src/sys/modules/usb/usie/@/amd64/compile/hs32/modules/usr/src/sys/modules/oce/@/amd64/compile/hs32/modules/usr/src/sys/modules/khelp/h_ertt/@/dev/ie/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/s3/@/amd64/compile/hs32/modules/usr/src/sys/modules/usb/usie/@/amd64/compile/hs32/modules/usr/src/sys/modules/oce/@/amd64/compile/hs32/modules/usr/src/sys/modules/khelp/h_ertt/@/dev/ie/if_ie507.h |
/* * $FreeBSD: release/9.1.0/sys/dev/ie/if_ie507.h 112734 2003-03-28 06:27:08Z mdodd $ * Definitions for 3C507 */ #define IE507_CTRL 6 /* control port */ #define IE507_ICTRL 10 /* interrupt control */ #define IE507_ATTN 11 /* any write here sends a chan attn */ #define IE507_ROM 13 /* rom configuration? */ #define IE507_MADDR 14 /* shared memory configuration */ #define IE507_IRQ 15 /* IRQ configuration */ /* Bank 0 -- "*3COM*" signature */ #define EL_SIG 0 /* offset of ASCII signature -- "*3COM*" */ /* Bank 1 -- ethernet address */ #define EL_ADDR 0 /* offset of card's ethernet address */ /* Bank 2 -- card part #, revision, date of manufacture */ #define EL_TYPE 0 /* offset of card part # */ #define EL_TYPE_HI 0 /* offset of card part # -- high byte */ #define EL_TYPE_MID 1 /* offset of card part # -- middle byte */ #define EL_TYPE_LOW 2 /* offset of card part # -- low byte */ #define EL_REV 3 /* offset of card revision, in BCD */ #define EL_DOM_DAY 4 /* offset of date of manf: day in BCD */ #define EL_DOM_MY 4 /* offset of date of manf: month, year in BCD */ /* * Definitions for non-bankswitched registers */ /* General control register */ #define EL_CTRL_BNK0 0x00 /* register bank 0 */ #define EL_CTRL_BNK1 0x01 /* register bank 1 */ #define EL_CTRL_BNK2 0x02 /* register bank 2 */ #define EL_CTRL_IEN 0x04 /* interrupt enable */ #define EL_CTRL_INTL 0x08 /* interrupt active latch */ #define EL_CTRL_16BIT 0x10 /* bus width; clear = 8-bit, set = 16-bit */ #define EL_CTRL_LOOP 0x20 /* loopback mode */ #define EL_CTRL_NRST 0x80 /* turn off to reset */ #define EL_CTRL_RESET (EL_CTRL_LOOP) #define EL_CTRL_NORMAL (EL_CTRL_NRST | EL_CTRL_IEN | EL_CTRL_BNK1) /* ROM & media control register */ #define EL_MEDIA_MASK 0x80 /* m1 = (EL_MEDIA register) & EL_MEDIA_MASK */ #define EL_MEDIA_SHIFT 7 /* media index = m1 >> EL_MEDIA_SHIFT */ /* shared memory control register */ #define EL_MADDR_HIGH 0x20 /* memory mapping above 15Meg */ #define EL_MADDR_MASK 0x1c /* m1 = (EL_MADDR register) & EL_MADDR_MASK */ #define EL_MADDR_SHIFT 12 /* m2 = m1 << EL_MADDR_SHIFT */ #define EL_MADDR_BASE 0xc0000 /* maddr = m2 + EL_MADDR_BASE */ #define EL_MSIZE_MASK 0x03 /* m1 = (EL_MADDR register) & EL_MSIZE_MASK */ #define EL_MSIZE_STEP 16384 /* msize = (m1 + 1) * EL_MSIZE_STEP */ /* interrupt control register */ #define EL_IRQ_MASK 0x0f /* irq = (EL_IRQ register) & EL_IRQ_MASK */ /* * Definitions for Bank 0 registers */ #define EL_SIG_LEN 6 /* signature length */ #define EL_SIGNATURE "*3COM*" /* * Definitions for Bank 1 registers */ #define EL_ADDR_LEN 6 /* ether address length */ /* * Definitions for Bank 2 registers */ #define EL_TYPE_LEN 3 /* card part # length */ /* * General card-specific macros and definitions */ #define EL_IOBASE_LOW 0x200 #define EL_IOBASE_HIGH 0x3e0 #define EL_IOSIZE 16 /* * XXX: It seems that the 3C507-TP is differentiated from AUI/BNC 3C507 * by part numbers, but I'm not sure how accurate this test is, seeing * as it's based on the sample of 3 cards I own (2AUI/BNC, 1 TP). */ #define EL_IS_TP(type) ((type)[EL_TYPE_MID] > 0x70) #define EL_CARD_BNC 0 /* regular AUI/BNC 3C507 */ #define EL_CARD_TP 1 /* 3C507-TP -- no AUI/BNC */