| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/sound/driver/driver/@/i386/i386/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/sound/driver/driver/@/i386/i386/mpboot.s |
/*-
* Copyright (c) 1995 Jack F. Vogel
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*
* mpboot.s: FreeBSD machine support for the Intel MP Spec
* multiprocessor systems.
*
* $FreeBSD: release/9.1.0/sys/i386/i386/mpboot.s 214631 2010-11-01 18:18:46Z jhb $
*/
#include "opt_pmap.h"
#include <machine/asmacros.h> /* miscellaneous asm macros */
#include <x86/apicreg.h>
#include <machine/specialreg.h>
#include "assym.s"
#define R(x) ((x)-KERNBASE)
/*
* this code MUST be enabled here and in mp_machdep.c
* it follows the very early stages of AP boot by placing values in CMOS ram.
* it NORMALLY will never be needed and thus the primitive method for enabling.
*
#define CHECK_POINTS
*/
#if defined(CHECK_POINTS) && !defined(PC98)
#define CMOS_REG (0x70)
#define CMOS_DATA (0x71)
#define CHECKPOINT(A,D) \
movb $(A),%al ; \
outb %al,$CMOS_REG ; \
movb $(D),%al ; \
outb %al,$CMOS_DATA
#else
#define CHECKPOINT(A,D)
#endif /* CHECK_POINTS */
/*
* the APs enter here from their trampoline code (bootMP, below)
*/
.p2align 4
NON_GPROF_ENTRY(MPentry)
CHECKPOINT(0x36, 3)
/*
* Enable features on this processor. We don't support SMP on
* CPUs older than a Pentium, so we know that we can use the cpuid
* instruction.
*/
movl $1,%eax
cpuid /* Retrieve features */
movl %cr4,%eax
#ifndef DISABLE_PSE
testl $CPUID_PSE,%edx
jz 1f
orl $CR4_PSE,%eax /* Enable PSE */
1:
#endif
#ifndef DISABLE_PG_G
testl $CPUID_PGE,%edx
jz 1f
orl $CR4_PGE,%eax /* Enable PGE */
1:
#endif
testl $CPUID_VME,%edx
jz 1f
orl $CR4_VME,%eax /* Enable VME */
1:
movl %eax,%cr4
/* Now enable paging mode */
#ifdef PAE
movl R(IdlePDPT), %eax
movl %eax, %cr3
movl %cr4, %eax
orl $CR4_PAE, %eax
movl %eax, %cr4
#else
movl R(IdlePTD), %eax
movl %eax,%cr3
#endif
movl %cr0,%eax
orl $CR0_PE|CR0_PG,%eax /* enable paging */
movl %eax,%cr0 /* let the games begin! */
movl bootSTK,%esp /* boot stack end loc. */
pushl $mp_begin /* jump to high mem */
ret
/*
* Wait for the booting CPU to signal startup
*/
mp_begin: /* now running relocated at KERNBASE */
CHECKPOINT(0x37, 4)
call init_secondary /* load i386 tables */
/*
* This is the embedded trampoline or bootstrap that is
* copied into 'real-mode' low memory, it is where the
* secondary processor "wakes up". When it is executed
* the processor will eventually jump into the routine
* MPentry, which resides in normal kernel text above
* 1Meg. -jackv
*/
.data
ALIGN_DATA /* just to be sure */
BOOTMP1:
NON_GPROF_ENTRY(bootMP)
.code16
cli
CHECKPOINT(0x34, 1)
/* First guarantee a 'clean slate' */
xorl %eax, %eax
movl %eax, %ebx
movl %eax, %ecx
movl %eax, %edx
movl %eax, %esi
movl %eax, %edi
/* set up data segments */
mov %cs, %ax
mov %ax, %ds
mov %ax, %es
mov %ax, %fs
mov %ax, %gs
mov %ax, %ss
mov $(boot_stk-bootMP), %esp
/* Now load the global descriptor table */
lgdt MP_GDTptr-bootMP
/* Enable protected mode */
movl %cr0, %eax
orl $CR0_PE, %eax
movl %eax, %cr0
/*
* make intrasegment jump to flush the processor pipeline and
* reload CS register
*/
pushl $0x18
pushl $(protmode-bootMP)
lretl
.code32
protmode:
CHECKPOINT(0x35, 2)
/*
* we are NOW running for the first time with %eip
* having the full physical address, BUT we still
* are using a segment descriptor with the origin
* not matching the booting kernel.
*
* SO NOW... for the BIG Jump into kernel's segment
* and physical text above 1 Meg.
*/
mov $0x10, %ebx
movw %bx, %ds
movw %bx, %es
movw %bx, %fs
movw %bx, %gs
movw %bx, %ss
.globl bigJump
bigJump:
/* this will be modified by mpInstallTramp() */
ljmp $0x08, $0 /* far jmp to MPentry() */
dead: hlt /* We should never get here */
jmp dead
/*
* MP boot strap Global Descriptor Table
*/
.p2align 4
.globl MP_GDT
.globl bootCodeSeg
.globl bootDataSeg
MP_GDT:
nulldesc: /* offset = 0x0 */
.word 0x0
.word 0x0
.byte 0x0
.byte 0x0
.byte 0x0
.byte 0x0
kernelcode: /* offset = 0x08 */
.word 0xffff /* segment limit 0..15 */
.word 0x0000 /* segment base 0..15 */
.byte 0x0 /* segment base 16..23; set for 0K */
.byte 0x9f /* flags; Type */
.byte 0xcf /* flags; Limit */
.byte 0x0 /* segment base 24..32 */
kerneldata: /* offset = 0x10 */
.word 0xffff /* segment limit 0..15 */
.word 0x0000 /* segment base 0..15 */
.byte 0x0 /* segment base 16..23; set for 0k */
.byte 0x93 /* flags; Type */
.byte 0xcf /* flags; Limit */
.byte 0x0 /* segment base 24..32 */
bootcode: /* offset = 0x18 */
.word 0xffff /* segment limit 0..15 */
bootCodeSeg: /* this will be modified by mpInstallTramp() */
.word 0x0000 /* segment base 0..15 */
.byte 0x00 /* segment base 16...23; set for 0x000xx000 */
.byte 0x9e /* flags; Type */
.byte 0xcf /* flags; Limit */
.byte 0x0 /*segment base 24..32 */
bootdata: /* offset = 0x20 */
.word 0xffff
bootDataSeg: /* this will be modified by mpInstallTramp() */
.word 0x0000 /* segment base 0..15 */
.byte 0x00 /* segment base 16...23; set for 0x000xx000 */
.byte 0x92
.byte 0xcf
.byte 0x0
/*
* GDT pointer for the lgdt call
*/
.globl mp_gdtbase
MP_GDTptr:
mp_gdtlimit:
.word 0x0028
mp_gdtbase: /* this will be modified by mpInstallTramp() */
.long 0
.space 0x100 /* space for boot_stk - 1st temporary stack */
boot_stk:
BOOTMP2:
.globl bootMP_size
bootMP_size:
.long BOOTMP2 - BOOTMP1