| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/usb/ums/@/dev/sk/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/usb/ums/@/dev/sk/yukonreg.h |
/* $OpenBSD: yukonreg.h,v 1.2 2003/08/12 05:23:06 nate Exp $ */ /*- * Copyright (c) 2003 Nathan L. Binkert <binkertn@umich.edu> * * Permission to use, copy, modify, and distribute this software for any * purpose with or without fee is hereby granted, provided that the above * copyright notice and this permission notice appear in all copies. * * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR * ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN * ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF * OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE. * * $FreeBSD: release/9.1.0/sys/dev/sk/yukonreg.h 158070 2006-04-27 05:59:09Z yongari $ */ /* General Purpose Status Register (GPSR) */ #define YUKON_GPSR 0x0000 #define YU_GPSR_SPEED 0x8000 /* speed 0 - 10Mbps, 1 - 100Mbps */ #define YU_GPSR_DUPLEX 0x4000 /* 0 - half duplex, 1 - full duplex */ #define YU_GPSR_FCTL_TX 0x2000 /* Tx flow control, 1 - disabled */ #define YU_GPSR_LINK 0x1000 /* link status (down/up) */ #define YU_GPSR_PAUSE 0x0800 /* flow control enable/disable */ #define YU_GPSR_TX_IN_PROG 0x0400 /* transmit in progress */ #define YU_GPSR_EXCESS_COL 0x0200 /* excessive collisions occurred */ #define YU_GPSR_LATE_COL 0x0100 /* late collision occurred */ #define YU_GPSR_MII_PHY_STC 0x0020 /* MII PHY status change */ #define YU_GPSR_GIG_SPEED 0x0010 /* Gigabit Speed (0 - use speed bit) */ #define YU_GPSR_PARTITION 0x0008 /* partition mode */ #define YU_GPSR_FCTL_RX 0x0004 /* Rx flow control, 1 - disabled */ #define YU_GPSR_PROMS_EN 0x0002 /* promiscuous mode, 1 - enabled */ /* General Purpose Control Register (GPCR) */ #define YUKON_GPCR 0x0004 #define YU_GPCR_FCTL_TX_DIS 0x2000 /* Disable Tx flow control 802.3x */ #define YU_GPCR_TXEN 0x1000 /* Transmit Enable */ #define YU_GPCR_RXEN 0x0800 /* Receive Enable */ #define YU_GPCR_BURSTEN 0x0400 /* Burst Mode Enable */ #define YU_GPCR_LPBK 0x0200 /* MAC Loopback Enable */ #define YU_GPCR_PAR 0x0100 /* Partition Enable */ #define YU_GPCR_GIG 0x0080 /* Gigabit Speed 1000Mbps */ #define YU_GPCR_FLP 0x0040 /* Force Link Pass */ #define YU_GPCR_DUPLEX 0x0020 /* Duplex Enable */ #define YU_GPCR_FCTL_RX_DIS 0x0010 /* Disable Rx flow control 802.3x */ #define YU_GPCR_SPEED 0x0008 /* Port Speed 100Mbps */ #define YU_GPCR_DPLX_DIS 0x0004 /* Disable Auto-Update for duplex */ #define YU_GPCR_FCTL_DIS 0x0002 /* Disable Auto-Update for 802.3x */ #define YU_GPCR_SPEED_DIS 0x0001 /* Disable Auto-Update for speed */ /* Transmit Control Register (TCR) */ #define YUKON_TCR 0x0008 #define YU_TCR_FJ 0x8000 /* force jam / flow control */ #define YU_TCR_CRCD 0x4000 /* insert CRC (0 - enable) */ #define YU_TCR_PADD 0x2000 /* pad packets to 64b (0 - enable) */ #define YU_TCR_COLTH 0x1c00 /* collision threshold */ /* Receive Control Register (RCR) */ #define YUKON_RCR 0x000c #define YU_RCR_UFLEN 0x8000 /* unicast filter enable */ #define YU_RCR_MUFLEN 0x4000 /* multicast filter enable */ #define YU_RCR_CRCR 0x2000 /* remove CRC */ #define YU_RCR_PASSFC 0x1000 /* pass flow control packets */ /* Transmit Flow Control Register (TFCR) */ #define YUKON_TFCR 0x0010 /* Pause Time */ /* Transmit Parameter Register (TPR) */ #define YUKON_TPR 0x0014 #define YU_TPR_JAM_LEN(x) (((x) & 0x3) << 14) #define YU_TPR_JAM_IPG(x) (((x) & 0x1f) << 9) #define YU_TPR_JAM2DATA_IPG(x) (((x) & 0x1f) << 4) /* Serial Mode Register (SMR) */ #define YUKON_SMR 0x0018 #define YU_SMR_DATA_BLIND(x) (((x) & 0x1f) << 11) #define YU_SMR_LIMIT4 0x0400 /* reset after 16 / 4 collisions */ #define YU_SMR_MFL_JUMBO 0x0100 /* max frame length for jumbo frames */ #define YU_SMR_MFL_VLAN 0x0200 /* max frame length + vlan tag */ #define YU_SMR_IPG_DATA(x) ((x) & 0x1f) /* Source Address Low #1 (SAL1) */ #define YUKON_SAL1 0x001c /* SA1[15:0] */ /* Source Address Middle #1 (SAM1) */ #define YUKON_SAM1 0x0020 /* SA1[31:16] */ /* Source Address High #1 (SAH1) */ #define YUKON_SAH1 0x0024 /* SA1[47:32] */ /* Source Address Low #2 (SAL2) */ #define YUKON_SAL2 0x0028 /* SA2[15:0] */ /* Source Address Middle #2 (SAM2) */ #define YUKON_SAM2 0x002c /* SA2[31:16] */ /* Source Address High #2 (SAH2) */ #define YUKON_SAH2 0x0030 /* SA2[47:32] */ /* Multicatst Address Hash Register 1 (MCAH1) */ #define YUKON_MCAH1 0x0034 /* Multicatst Address Hash Register 2 (MCAH2) */ #define YUKON_MCAH2 0x0038 /* Multicatst Address Hash Register 3 (MCAH3) */ #define YUKON_MCAH3 0x003c /* Multicatst Address Hash Register 4 (MCAH4) */ #define YUKON_MCAH4 0x0040 /* Transmit Interrupt Register (TIR) */ #define YUKON_TIR 0x0044 #define YU_TIR_OUT_UNICAST 0x0001 /* Num Unicast Packets Transmitted */ #define YU_TIR_OUT_BROADCAST 0x0002 /* Num Broadcast Packets Transmitted */ #define YU_TIR_OUT_PAUSE 0x0004 /* Num Pause Packets Transmitted */ #define YU_TIR_OUT_MULTICAST 0x0008 /* Num Multicast Packets Transmitted */ #define YU_TIR_OUT_OCTETS 0x0030 /* Num Bytes Transmitted */ #define YU_TIR_OUT_64_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_127_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_255_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_511_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_1023_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_1518_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_MAX_OCTETS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_SPARE 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_COLLISIONS 0x0000 /* Num Packets Transmitted */ #define YU_TIR_OUT_LATE 0x0000 /* Num Packets Transmitted */ /* Receive Interrupt Register (RIR) */ #define YUKON_RIR 0x0048 /* Transmit and Receive Interrupt Register (TRIR) */ #define YUKON_TRIR 0x004c /* Transmit Interrupt Mask Register (TIMR) */ #define YUKON_TIMR 0x0050 /* Receive Interrupt Mask Register (RIMR) */ #define YUKON_RIMR 0x0054 /* Transmit and Receive Interrupt Mask Register (TRIMR) */ #define YUKON_TRIMR 0x0058 /* SMI Control Register (SMICR) */ #define YUKON_SMICR 0x0080 #define YU_SMICR_PHYAD(x) (((x) & 0x1f) << 11) #define YU_SMICR_REGAD(x) (((x) & 0x1f) << 6) #define YU_SMICR_OPCODE 0x0020 /* opcode (0 - write, 1 - read) */ #define YU_SMICR_OP_READ 0x0020 /* opcode read */ #define YU_SMICR_OP_WRITE 0x0000 /* opcode write */ #define YU_SMICR_READ_VALID 0x0010 /* read valid */ #define YU_SMICR_BUSY 0x0008 /* busy (writing) */ /* SMI Data Register (SMIDR) */ #define YUKON_SMIDR 0x0084 /* PHY Addres Register (PAR) */ #define YUKON_PAR 0x0088 #define YU_PAR_MIB_CLR 0x0020 /* MIB Counters Clear Mode */ #define YU_PAR_LOAD_TSTCNT 0x0010 /* Load count 0xfffffff0 into cntr */ /* Receive status */ #define YU_RXSTAT_FOFL 0x00000001 /* Rx FIFO overflow */ #define YU_RXSTAT_CRCERR 0x00000002 /* CRC error */ #define YU_RXSTAT_FRAGMENT 0x00000008 /* fragment */ #define YU_RXSTAT_LONGERR 0x00000010 /* too long packet */ #define YU_RXSTAT_MIIERR 0x00000020 /* MII error */ #define YU_RXSTAT_BADFC 0x00000040 /* bad flow-control packet */ #define YU_RXSTAT_GOODFC 0x00000080 /* good flow-control packet */ #define YU_RXSTAT_RXOK 0x00000100 /* receice OK (Good packet) */ #define YU_RXSTAT_BROADCAST 0x00000200 /* broadcast packet */ #define YU_RXSTAT_MULTICAST 0x00000400 /* multicast packet */ #define YU_RXSTAT_RUNT 0x00000800 /* undersize packet */ #define YU_RXSTAT_JABBER 0x00001000 /* jabber packet */ #define YU_RXSTAT_VLAN 0x00002000 /* VLAN packet */ #define YU_RXSTAT_LENSHIFT 16 #define YU_RXSTAT_BYTES(x) ((x) >> YU_RXSTAT_LENSHIFT)