| Current Path : /sys/amd64/compile/hs32/modules/usr/src/sys/modules/xl/@/dev/ath/ath_hal/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/amd64/compile/hs32/modules/usr/src/sys/modules/xl/@/dev/ath/ath_hal/ah_desc.h |
/*
* Copyright (c) 2002-2008 Sam Leffler, Errno Consulting
* Copyright (c) 2002-2008 Atheros Communications, Inc.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
*
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
* ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
* ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
* OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
*
* $FreeBSD: release/9.1.0/sys/dev/ath/ath_hal/ah_desc.h 224538 2011-07-31 03:33:02Z adrian $
*/
#ifndef _DEV_ATH_DESC_H
#define _DEV_ATH_DESC_H
#include "opt_ah.h" /* NB: required for AH_SUPPORT_AR5416 */
/*
* Transmit descriptor status. This structure is filled
* in only after the tx descriptor process method finds a
* ``done'' descriptor; at which point it returns something
* other than HAL_EINPROGRESS.
*
* Note that ts_antenna may not be valid for all h/w. It
* should be used only if non-zero.
*/
struct ath_tx_status {
uint16_t ts_seqnum; /* h/w assigned sequence number */
uint16_t ts_tstamp; /* h/w assigned timestamp */
uint8_t ts_status; /* frame status, 0 => xmit ok */
uint8_t ts_rate; /* h/w transmit rate index */
int8_t ts_rssi; /* tx ack RSSI */
uint8_t ts_shortretry; /* # short retries */
uint8_t ts_longretry; /* # long retries */
uint8_t ts_virtcol; /* virtual collision count */
uint8_t ts_antenna; /* antenna information */
uint8_t ts_finaltsi; /* final transmit series index */
#ifdef AH_SUPPORT_AR5416
/* 802.11n status */
uint8_t ts_flags; /* misc flags */
int8_t ts_rssi_ctl[3]; /* tx ack RSSI [ctl, chain 0-2] */
int8_t ts_rssi_ext[3]; /* tx ack RSSI [ext, chain 0-2] */
/* #define ts_rssi ts_rssi_combined */
uint32_t ts_ba_low; /* blockack bitmap low */
uint32_t ts_ba_high; /* blockack bitmap high */
uint32_t ts_evm0; /* evm bytes */
uint32_t ts_evm1;
uint32_t ts_evm2;
#endif /* AH_SUPPORT_AR5416 */
};
/* bits found in ts_status */
#define HAL_TXERR_XRETRY 0x01 /* excessive retries */
#define HAL_TXERR_FILT 0x02 /* blocked by tx filtering */
#define HAL_TXERR_FIFO 0x04 /* fifo underrun */
#define HAL_TXERR_XTXOP 0x08 /* txop exceeded */
#define HAL_TXERR_TIMER_EXPIRED 0x10 /* Tx timer expired */
/* bits found in ts_flags */
#define HAL_TX_BA 0x01 /* Block Ack seen */
#define HAL_TX_AGGR 0x02 /* Aggregate */
#define HAL_TX_DESC_CFG_ERR 0x10 /* Error in 20/40 desc config */
#define HAL_TX_DATA_UNDERRUN 0x20 /* Tx buffer underrun */
#define HAL_TX_DELIM_UNDERRUN 0x40 /* Tx delimiter underrun */
/*
* Receive descriptor status. This structure is filled
* in only after the rx descriptor process method finds a
* ``done'' descriptor; at which point it returns something
* other than HAL_EINPROGRESS.
*
* If rx_status is zero, then the frame was received ok;
* otherwise the error information is indicated and rs_phyerr
* contains a phy error code if HAL_RXERR_PHY is set. In general
* the frame contents is undefined when an error occurred thought
* for some errors (e.g. a decryption error), it may be meaningful.
*
* Note that the receive timestamp is expanded using the TSF to
* at least 15 bits (regardless of what the h/w provides directly).
* Newer hardware supports a full 32-bits; use HAL_CAP_32TSTAMP to
* find out if the hardware is capable.
*
* rx_rssi is in units of dbm above the noise floor. This value
* is measured during the preamble and PLCP; i.e. with the initial
* 4us of detection. The noise floor is typically a consistent
* -96dBm absolute power in a 20MHz channel.
*/
struct ath_rx_status {
uint16_t rs_datalen; /* rx frame length */
uint8_t rs_status; /* rx status, 0 => recv ok */
uint8_t rs_phyerr; /* phy error code */
int8_t rs_rssi; /* rx frame RSSI (combined for 11n) */
uint8_t rs_keyix; /* key cache index */
uint8_t rs_rate; /* h/w receive rate index */
uint8_t rs_more; /* more descriptors follow */
uint32_t rs_tstamp; /* h/w assigned timestamp */
uint32_t rs_antenna; /* antenna information */
#ifdef AH_SUPPORT_AR5416
/* 802.11n status */
int8_t rs_rssi_ctl[3]; /* rx frame RSSI [ctl, chain 0-2] */
int8_t rs_rssi_ext[3]; /* rx frame RSSI [ext, chain 0-2] */
uint8_t rs_isaggr; /* is part of the aggregate */
uint8_t rs_moreaggr; /* more frames in aggr to follow */
uint8_t rs_num_delims; /* number of delims in aggr */
uint8_t rs_flags; /* misc flags */
uint32_t rs_evm0; /* evm bytes */
uint32_t rs_evm1;
uint32_t rs_evm2;
uint32_t rs_evm3; /* needed for ar9300 and later */
uint32_t rs_evm4; /* needed for ar9300 and later */
#endif /* AH_SUPPORT_AR5416 */
};
/* bits found in rs_status */
#define HAL_RXERR_CRC 0x01 /* CRC error on frame */
#define HAL_RXERR_PHY 0x02 /* PHY error, rs_phyerr is valid */
#define HAL_RXERR_FIFO 0x04 /* fifo overrun */
#define HAL_RXERR_DECRYPT 0x08 /* non-Michael decrypt error */
#define HAL_RXERR_MIC 0x10 /* Michael MIC decrypt error */
/* bits found in rs_flags */
#define HAL_RX_MORE 0x01 /* more descriptors follow */
#define HAL_RX_MORE_AGGR 0x02 /* more frames in aggr */
#define HAL_RX_GI 0x04 /* full gi */
#define HAL_RX_2040 0x08 /* 40 Mhz */
#define HAL_RX_DELIM_CRC_PRE 0x10 /* crc error in delimiter pre */
#define HAL_RX_DELIM_CRC_POST 0x20 /* crc error in delim after */
#define HAL_RX_DECRYPT_BUSY 0x40 /* decrypt was too slow */
#define HAL_RX_HI_RX_CHAIN 0x80 /* SM power save: hi Rx chain control */
enum {
HAL_PHYERR_UNDERRUN = 0, /* Transmit underrun */
HAL_PHYERR_TIMING = 1, /* Timing error */
HAL_PHYERR_PARITY = 2, /* Illegal parity */
HAL_PHYERR_RATE = 3, /* Illegal rate */
HAL_PHYERR_LENGTH = 4, /* Illegal length */
HAL_PHYERR_RADAR = 5, /* Radar detect */
HAL_PHYERR_SERVICE = 6, /* Illegal service */
HAL_PHYERR_TOR = 7, /* Transmit override receive */
/* NB: these are specific to the 5212 and later */
HAL_PHYERR_OFDM_TIMING = 17, /* */
HAL_PHYERR_OFDM_SIGNAL_PARITY = 18, /* */
HAL_PHYERR_OFDM_RATE_ILLEGAL = 19, /* */
HAL_PHYERR_OFDM_LENGTH_ILLEGAL = 20, /* */
HAL_PHYERR_OFDM_POWER_DROP = 21, /* */
HAL_PHYERR_OFDM_SERVICE = 22, /* */
HAL_PHYERR_OFDM_RESTART = 23, /* */
HAL_PHYERR_FALSE_RADAR_EXT = 24, /* */
HAL_PHYERR_CCK_TIMING = 25, /* */
HAL_PHYERR_CCK_HEADER_CRC = 26, /* */
HAL_PHYERR_CCK_RATE_ILLEGAL = 27, /* */
HAL_PHYERR_CCK_SERVICE = 30, /* */
HAL_PHYERR_CCK_RESTART = 31, /* */
HAL_PHYERR_CCK_LENGTH_ILLEGAL = 32, /* */
HAL_PHYERR_CCK_POWER_DROP = 33, /* */
/* AR5416 and later */
HAL_PHYERR_HT_CRC_ERROR = 34, /* */
HAL_PHYERR_HT_LENGTH_ILLEGAL = 35, /* */
HAL_PHYERR_HT_RATE_ILLEGAL = 36, /* */
};
/* value found in rs_keyix to mark invalid entries */
#define HAL_RXKEYIX_INVALID ((uint8_t) -1)
/* value used to specify no encryption key for xmit */
#define HAL_TXKEYIX_INVALID ((u_int) -1)
/* XXX rs_antenna definitions */
/*
* Definitions for the software frame/packet descriptors used by
* the Atheros HAL. This definition obscures hardware-specific
* details from the driver. Drivers are expected to fillin the
* portions of a descriptor that are not opaque then use HAL calls
* to complete the work. Status for completed frames is returned
* in a device-independent format.
*/
#ifdef AH_SUPPORT_AR5416
#define HAL_DESC_HW_SIZE 20
#else
#define HAL_DESC_HW_SIZE 4
#endif /* AH_SUPPORT_AR5416 */
struct ath_desc {
/*
* The following definitions are passed directly
* the hardware and managed by the HAL. Drivers
* should not touch those elements marked opaque.
*/
uint32_t ds_link; /* phys address of next descriptor */
uint32_t ds_data; /* phys address of data buffer */
uint32_t ds_ctl0; /* opaque DMA control 0 */
uint32_t ds_ctl1; /* opaque DMA control 1 */
uint32_t ds_hw[HAL_DESC_HW_SIZE]; /* opaque h/w region */
};
struct ath_desc_status {
union {
struct ath_tx_status tx;/* xmit status */
struct ath_rx_status rx;/* recv status */
} ds_us;
};
#define ds_txstat ds_us.tx
#define ds_rxstat ds_us.rx
/* flags passed to tx descriptor setup methods */
#define HAL_TXDESC_CLRDMASK 0x0001 /* clear destination filter mask */
#define HAL_TXDESC_NOACK 0x0002 /* don't wait for ACK */
#define HAL_TXDESC_RTSENA 0x0004 /* enable RTS */
#define HAL_TXDESC_CTSENA 0x0008 /* enable CTS */
#define HAL_TXDESC_INTREQ 0x0010 /* enable per-descriptor interrupt */
#define HAL_TXDESC_VEOL 0x0020 /* mark virtual EOL */
/* NB: this only affects frame, not any RTS/CTS */
#define HAL_TXDESC_DURENA 0x0040 /* enable h/w write of duration field */
#define HAL_TXDESC_EXT_ONLY 0x0080 /* send on ext channel only (11n) */
#define HAL_TXDESC_EXT_AND_CTL 0x0100 /* send on ext + ctl channels (11n) */
#define HAL_TXDESC_VMF 0x0200 /* virtual more frag */
/* flags passed to rx descriptor setup methods */
#define HAL_RXDESC_INTREQ 0x0020 /* enable per-descriptor interrupt */
#endif /* _DEV_ATH_DESC_H */