| Current Path : /sys/dev/ed/ |
FreeBSD hs32.drive.ne.jp 9.1-RELEASE FreeBSD 9.1-RELEASE #1: Wed Jan 14 12:18:08 JST 2015 root@hs32.drive.ne.jp:/sys/amd64/compile/hs32 amd64 |
| Current File : //sys/dev/ed/if_ed_novell.c |
/*-
* Copyright (c) 2005, M. Warner Losh
* All rights reserved.
* Copyright (c) 1995, David Greenman
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice unmodified, this list of conditions, and the following
* disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*/
#include <sys/cdefs.h>
__FBSDID("$FreeBSD: release/9.1.0/sys/dev/ed/if_ed_novell.c 211793 2010-08-25 02:09:07Z imp $");
#include "opt_ed.h"
#include <sys/param.h>
#include <sys/systm.h>
#include <sys/sockio.h>
#include <sys/mbuf.h>
#include <sys/kernel.h>
#include <sys/socket.h>
#include <sys/syslog.h>
#include <sys/bus.h>
#include <machine/bus.h>
#include <sys/rman.h>
#include <machine/resource.h>
#include <net/ethernet.h>
#include <net/if.h>
#include <net/if_arp.h>
#include <net/if_dl.h>
#include <net/if_mib.h>
#include <net/if_media.h>
#include <net/bpf.h>
#include <dev/ed/if_edreg.h>
#include <dev/ed/if_edvar.h>
static int ed_probe_gwether(device_t);
/*
* Probe and vendor-specific initialization routine for NE1000/2000 boards
*/
int
ed_probe_Novell_generic(device_t dev, int flags)
{
struct ed_softc *sc = device_get_softc(dev);
u_int memsize;
int error;
u_char tmp;
static char test_pattern[32] = "THIS is A memory TEST pattern";
char test_buffer[32];
/* Reset the board */
if (ED_FLAGS_GETTYPE(flags) == ED_FLAGS_GWETHER) {
ed_asic_outb(sc, ED_NOVELL_RESET, 0);
DELAY(200);
}
tmp = ed_asic_inb(sc, ED_NOVELL_RESET);
/*
* I don't know if this is necessary; probably cruft leftover from
* Clarkson packet driver code. Doesn't do a thing on the boards I've
* tested. -DG
*/
ed_asic_outb(sc, ED_NOVELL_RESET, tmp);
DELAY(5000);
/*
* This is needed because some NE clones apparently don't reset the
* NIC properly (or the NIC chip doesn't reset fully on power-up) XXX
* - this makes the probe invasive! ...Done against my better
* judgement. -DLG
*/
ed_nic_outb(sc, ED_P0_CR, ED_CR_RD2 | ED_CR_STP);
DELAY(5000);
/* Make sure that we really have an 8390 based board */
if (!ed_probe_generic8390(sc))
return (ENXIO);
sc->vendor = ED_VENDOR_NOVELL;
sc->mem_shared = 0;
sc->cr_proto = ED_CR_RD2;
/*
* Test the ability to read and write to the NIC memory. This has the
* side affect of determining if this is an NE1000 or an NE2000.
*/
/*
* This prevents packets from being stored in the NIC memory when the
* readmem routine turns on the start bit in the CR.
*/
ed_nic_outb(sc, ED_P0_RCR, ED_RCR_MON);
/* Temporarily initialize DCR for byte operations */
ed_nic_outb(sc, ED_P0_DCR, ED_DCR_FT1 | ED_DCR_LS);
ed_nic_outb(sc, ED_P0_PSTART, 8192 / ED_PAGE_SIZE);
ed_nic_outb(sc, ED_P0_PSTOP, 16384 / ED_PAGE_SIZE);
/*
* Some devices identify themselves. Some of those devices
* can't handle being probed, so we allow forcing a mode. If
* these flags are set, force it, otherwise probe.
*/
if (flags & ED_FLAGS_FORCE_8BIT_MODE) {
sc->isa16bit = 0;
sc->type = ED_TYPE_NE1000;
sc->type_str = "NE1000";
} else if (flags & ED_FLAGS_FORCE_16BIT_MODE) {
sc->isa16bit = 1;
sc->type = ED_TYPE_NE2000;
sc->type_str = "NE2000";
ed_nic_outb(sc, ED_P0_DCR, ED_DCR_WTS | ED_DCR_FT1 | ED_DCR_LS);
ed_nic_outb(sc, ED_P0_PSTART, 16384 / ED_PAGE_SIZE);
ed_nic_outb(sc, ED_P0_PSTOP, 32768 / ED_PAGE_SIZE);
} else {
/*
* Write a test pattern in byte mode. If this fails, then there
* probably isn't any memory at 8k - which likely means that the board
* is an NE2000.
*/
ed_pio_writemem(sc, test_pattern, 8192, sizeof(test_pattern));
ed_pio_readmem(sc, 8192, test_buffer, sizeof(test_pattern));
if (bcmp(test_pattern, test_buffer, sizeof(test_pattern)) == 0) {
sc->type = ED_TYPE_NE1000;
sc->type_str = "NE1000";
sc->isa16bit = 0;
} else {
/* Not an NE1000 - try NE2000 */
sc->isa16bit = 1;
ed_nic_outb(sc, ED_P0_DCR, ED_DCR_WTS | ED_DCR_FT1 | ED_DCR_LS);
ed_nic_outb(sc, ED_P0_PSTART, 16384 / ED_PAGE_SIZE);
ed_nic_outb(sc, ED_P0_PSTOP, 32768 / ED_PAGE_SIZE);
/*
* Write a test pattern in word mode. If this also fails, then
* we don't know what this board is.
*/
ed_pio_writemem(sc, test_pattern, 16384, sizeof(test_pattern));
ed_pio_readmem(sc, 16384, test_buffer, sizeof(test_pattern));
if (bcmp(test_pattern, test_buffer, sizeof(test_pattern)) == 0) {
sc->type = ED_TYPE_NE2000;
sc->type_str = "NE2000";
} else {
return (ENXIO);
}
}
}
sc->chip_type = ED_CHIP_TYPE_DP8390;
/* 8k of memory plus an additional 8k if 16bit */
memsize = 8192 + sc->isa16bit * 8192;
sc->mem_size = memsize;
/* NIC memory doesn't start at zero on an NE board */
/* The start address is tied to the bus width */
sc->mem_start = 8192 + sc->isa16bit * 8192;
sc->mem_end = sc->mem_start + memsize;
sc->tx_page_start = memsize / ED_PAGE_SIZE;
if (ED_FLAGS_GETTYPE(flags) == ED_FLAGS_GWETHER) {
error = ed_probe_gwether(dev);
if (error)
return (error);
}
/*
* Use one xmit buffer if < 16k, two buffers otherwise (if not told
* otherwise).
*/
if ((memsize < 16384) || (flags & ED_FLAGS_NO_MULTI_BUFFERING))
sc->txb_cnt = 1;
else
sc->txb_cnt = 2;
sc->rec_page_start = sc->tx_page_start + sc->txb_cnt * ED_TXBUF_SIZE;
sc->rec_page_stop = sc->tx_page_start + memsize / ED_PAGE_SIZE;
sc->mem_ring = sc->mem_start + sc->txb_cnt * ED_PAGE_SIZE * ED_TXBUF_SIZE;
/* clear any pending interrupts that might have occurred above */
ed_nic_outb(sc, ED_P0_ISR, 0xff);
sc->sc_write_mbufs = ed_pio_write_mbufs;
return (0);
}
int
ed_probe_Novell(device_t dev, int port_rid, int flags)
{
struct ed_softc *sc = device_get_softc(dev);
int error;
error = ed_alloc_port(dev, port_rid, ED_NOVELL_IO_PORTS);
if (error)
return (error);
sc->asic_offset = ED_NOVELL_ASIC_OFFSET;
sc->nic_offset = ED_NOVELL_NIC_OFFSET;
return ed_probe_Novell_generic(dev, flags);
}
static int
ed_probe_gwether(device_t dev)
{
int x, i, msize = 0;
bus_size_t mstart = 0;
char pbuf0[ED_PAGE_SIZE], pbuf[ED_PAGE_SIZE], tbuf[ED_PAGE_SIZE];
struct ed_softc *sc = device_get_softc(dev);
for (i = 0; i < ED_PAGE_SIZE; i++)
pbuf0[i] = 0;
/* Clear all the memory. */
for (x = 1; x < 256; x++)
ed_pio_writemem(sc, pbuf0, x * 256, ED_PAGE_SIZE);
/* Search for the start of RAM. */
for (x = 1; x < 256; x++) {
ed_pio_readmem(sc, x * 256, tbuf, ED_PAGE_SIZE);
if (bcmp(pbuf0, tbuf, ED_PAGE_SIZE) == 0) {
for (i = 0; i < ED_PAGE_SIZE; i++)
pbuf[i] = 255 - x;
ed_pio_writemem(sc, pbuf, x * 256, ED_PAGE_SIZE);
ed_pio_readmem(sc, x * 256, tbuf, ED_PAGE_SIZE);
if (bcmp(pbuf, tbuf, ED_PAGE_SIZE) == 0) {
mstart = x * ED_PAGE_SIZE;
msize = ED_PAGE_SIZE;
break;
}
}
}
if (mstart == 0) {
device_printf(dev, "Cannot find start of RAM.\n");
return (ENXIO);
}
/* Probe the size of RAM. */
for (x = (mstart / ED_PAGE_SIZE) + 1; x < 256; x++) {
ed_pio_readmem(sc, x * 256, tbuf, ED_PAGE_SIZE);
if (bcmp(pbuf0, tbuf, ED_PAGE_SIZE) == 0) {
for (i = 0; i < ED_PAGE_SIZE; i++)
pbuf[i] = 255 - x;
ed_pio_writemem(sc, pbuf, x * 256, ED_PAGE_SIZE);
ed_pio_readmem(sc, x * 256, tbuf, ED_PAGE_SIZE);
if (bcmp(pbuf, tbuf, ED_PAGE_SIZE) == 0)
msize += ED_PAGE_SIZE;
else {
break;
}
} else {
break;
}
}
if (msize == 0) {
device_printf(dev,
"Cannot find any RAM, start : %d, x = %d.\n",
(int)mstart, x);
return (ENXIO);
}
if (bootverbose)
device_printf(dev,
"RAM start at %d, size : %d.\n", (int)mstart, msize);
sc->mem_size = msize;
sc->mem_start = mstart;
sc->mem_end = msize + mstart;
sc->tx_page_start = mstart / ED_PAGE_SIZE;
return 0;
}
void
ed_Novell_read_mac(struct ed_softc *sc)
{
int n;
uint8_t romdata[16];
/*
* Most ne1000/ne2000 compatible cards have their MAC address
* located in the first few words of the address space. This seems
* universally true for ISA and PCI implementations, but PC Card
* devices seem to have more variance.
*/
ed_pio_readmem(sc, 0, romdata, 16);
for (n = 0; n < ETHER_ADDR_LEN; n++)
sc->enaddr[n] = romdata[n * (sc->isa16bit + 1)];
}