config root man

/* $FreeBSD: release/9.1.0/sys/dev/usb/controller/ehcireg.h 214349 2010-10-25 15:51:43Z nwhitehorn $ */
/*-
 * Copyright (c) 2001 The NetBSD Foundation, Inc.
 * All rights reserved.
 *
 * This code is derived from software contributed to The NetBSD Foundation
 * by Lennart Augustsson (lennart@augustsson.net).
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 *
 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
 * PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
 * POSSIBILITY OF SUCH DAMAGE.
 */

#ifndef _EHCIREG_H_
#define	_EHCIREG_H_

/* PCI config registers  */
#define	PCI_CBMEM		0x10	/* configuration base MEM */
#define	PCI_INTERFACE_EHCI	0x20
#define	PCI_USBREV		0x60	/* RO USB protocol revision */
#define	PCI_USB_REV_MASK	0xff
#define	PCI_USB_REV_PRE_1_0	0x00
#define	PCI_USB_REV_1_0		0x10
#define	PCI_USB_REV_1_1		0x11
#define	PCI_USB_REV_2_0		0x20
#define	PCI_EHCI_FLADJ		0x61	/* RW Frame len adj, SOF=59488+6*fladj */
#define	PCI_EHCI_PORTWAKECAP	0x62	/* RW Port wake caps (opt)  */

/* EHCI Extended Capabilities */
#define	EHCI_EC_LEGSUP		0x01
#define	EHCI_EECP_NEXT(x)	(((x) >> 8) & 0xff)
#define	EHCI_EECP_ID(x)		((x) & 0xff)

/* Legacy support extended capability */
#define	EHCI_LEGSUP_BIOS_SEM		0x02
#define	EHCI_LEGSUP_OS_SEM		0x03
#define	EHCI_LEGSUP_USBLEGCTLSTS	0x04

/* EHCI capability registers */
#define	EHCI_CAPLEN_HCIVERSION	0x00	/* RO Capability register length
					 * (least-significant byte) and 
					 * interface version number (two
					 * most significant)
					 */
#define EHCI_CAPLENGTH(x)	((x) & 0xff)
#define EHCI_HCIVERSION(x)	(((x) >> 16) & 0xffff)
#define	EHCI_HCSPARAMS		0x04	/* RO Structural parameters */
#define	EHCI_HCS_DEBUGPORT(x)	(((x) >> 20) & 0xf)
#define	EHCI_HCS_P_INDICATOR(x) ((x) & 0x10000)
#define	EHCI_HCS_N_CC(x)	(((x) >> 12) & 0xf)	/* # of companion ctlrs */
#define	EHCI_HCS_N_PCC(x)	(((x) >> 8) & 0xf)	/* # of ports per comp. */
#define	EHCI_HCS_PPC(x)		((x) & 0x10)	/* port power control */
#define	EHCI_HCS_N_PORTS(x)	((x) & 0xf)	/* # of ports */
#define	EHCI_HCCPARAMS		0x08	/* RO Capability parameters */
#define	EHCI_HCC_EECP(x)	(((x) >> 8) & 0xff)	/* extended ports caps */
#define	EHCI_HCC_IST(x)		(((x) >> 4) & 0xf)	/* isoc sched threshold */
#define	EHCI_HCC_ASPC(x)	((x) & 0x4)	/* async sched park cap */
#define	EHCI_HCC_PFLF(x)	((x) & 0x2)	/* prog frame list flag */
#define	EHCI_HCC_64BIT(x)	((x) & 0x1)	/* 64 bit address cap */
#define	EHCI_HCSP_PORTROUTE	0x0c	/* RO Companion port route description */

/* EHCI operational registers.  Offset given by EHCI_CAPLENGTH register */
#define	EHCI_USBCMD		0x00	/* RO, RW, WO Command register */
#define	EHCI_CMD_ITC_M		0x00ff0000	/* RW interrupt threshold ctrl */
#define	EHCI_CMD_ITC_1		0x00010000
#define	EHCI_CMD_ITC_2		0x00020000
#define	EHCI_CMD_ITC_4		0x00040000
#define	EHCI_CMD_ITC_8		0x00080000
#define	EHCI_CMD_ITC_16		0x00100000
#define	EHCI_CMD_ITC_32		0x00200000
#define	EHCI_CMD_ITC_64		0x00400000
#define	EHCI_CMD_ASPME		0x00000800	/* RW/RO async park enable */
#define	EHCI_CMD_ASPMC		0x00000300	/* RW/RO async park count */
#define	EHCI_CMD_LHCR		0x00000080	/* RW light host ctrl reset */
#define	EHCI_CMD_IAAD		0x00000040	/* RW intr on async adv door
						 * bell */
#define	EHCI_CMD_ASE		0x00000020	/* RW async sched enable */
#define	EHCI_CMD_PSE		0x00000010	/* RW periodic sched enable */
#define	EHCI_CMD_FLS_M		0x0000000c	/* RW/RO frame list size */
#define	EHCI_CMD_FLS(x)		(((x) >> 2) & 3)	/* RW/RO frame list size */
#define	EHCI_CMD_HCRESET	0x00000002	/* RW reset */
#define	EHCI_CMD_RS		0x00000001	/* RW run/stop */
#define	EHCI_USBSTS		0x04	/* RO, RW, RWC Status register */
#define	EHCI_STS_ASS		0x00008000	/* RO async sched status */
#define	EHCI_STS_PSS		0x00004000	/* RO periodic sched status */
#define	EHCI_STS_REC		0x00002000	/* RO reclamation */
#define	EHCI_STS_HCH		0x00001000	/* RO host controller halted */
#define	EHCI_STS_IAA		0x00000020	/* RWC interrupt on async adv */
#define	EHCI_STS_HSE		0x00000010	/* RWC host system error */
#define	EHCI_STS_FLR		0x00000008	/* RWC frame list rollover */
#define	EHCI_STS_PCD		0x00000004	/* RWC port change detect */
#define	EHCI_STS_ERRINT		0x00000002	/* RWC error interrupt */
#define	EHCI_STS_INT		0x00000001	/* RWC interrupt */
#define	EHCI_STS_INTRS(x)	((x) & 0x3f)

/*
 * NOTE: the doorbell interrupt is enabled, but the doorbell is never
 * used! SiS chipsets require this.
 */
#define	EHCI_NORMAL_INTRS	(EHCI_STS_IAA | EHCI_STS_HSE |	\
				EHCI_STS_PCD | EHCI_STS_ERRINT | EHCI_STS_INT)

#define	EHCI_USBINTR		0x08	/* RW Interrupt register */
#define	EHCI_INTR_IAAE		0x00000020	/* interrupt on async advance
						 * ena */
#define	EHCI_INTR_HSEE		0x00000010	/* host system error ena */
#define	EHCI_INTR_FLRE		0x00000008	/* frame list rollover ena */
#define	EHCI_INTR_PCIE		0x00000004	/* port change ena */
#define	EHCI_INTR_UEIE		0x00000002	/* USB error intr ena */
#define	EHCI_INTR_UIE		0x00000001	/* USB intr ena */

#define	EHCI_FRINDEX		0x0c	/* RW Frame Index register */

#define	EHCI_CTRLDSSEGMENT	0x10	/* RW Control Data Structure Segment */

#define	EHCI_PERIODICLISTBASE	0x14	/* RW Periodic List Base */
#define	EHCI_ASYNCLISTADDR	0x18	/* RW Async List Base */

#define	EHCI_CONFIGFLAG		0x40	/* RW Configure Flag register */
#define	EHCI_CONF_CF		0x00000001	/* RW configure flag */

#define	EHCI_PORTSC(n)		(0x40+(4*(n)))	/* RO, RW, RWC Port Status reg */
#define	EHCI_PS_WKOC_E		0x00400000	/* RW wake on over current ena */
#define	EHCI_PS_WKDSCNNT_E	0x00200000	/* RW wake on disconnect ena */
#define	EHCI_PS_WKCNNT_E	0x00100000	/* RW wake on connect ena */
#define	EHCI_PS_PTC		0x000f0000	/* RW port test control */
#define	EHCI_PS_PIC		0x0000c000	/* RW port indicator control */
#define	EHCI_PS_PO		0x00002000	/* RW port owner */
#define	EHCI_PS_PP		0x00001000	/* RW,RO port power */
#define	EHCI_PS_LS		0x00000c00	/* RO line status */
#define	EHCI_PS_IS_LOWSPEED(x)	(((x) & EHCI_PS_LS) == 0x00000400)
#define	EHCI_PS_PR		0x00000100	/* RW port reset */
#define	EHCI_PS_SUSP		0x00000080	/* RW suspend */
#define	EHCI_PS_FPR		0x00000040	/* RW force port resume */
#define	EHCI_PS_OCC		0x00000020	/* RWC over current change */
#define	EHCI_PS_OCA		0x00000010	/* RO over current active */
#define	EHCI_PS_PEC		0x00000008	/* RWC port enable change */
#define	EHCI_PS_PE		0x00000004	/* RW port enable */
#define	EHCI_PS_CSC		0x00000002	/* RWC connect status change */
#define	EHCI_PS_CS		0x00000001	/* RO connect status */
#define	EHCI_PS_CLEAR		(EHCI_PS_OCC | EHCI_PS_PEC | EHCI_PS_CSC)

#define	EHCI_USBMODE		0x68	/* RW USB Device mode register */
#define	EHCI_UM_CM		0x00000003	/* R/WO Controller Mode */
#define	EHCI_UM_CM_IDLE		0x0	/* Idle */
#define	EHCI_UM_CM_HOST		0x3	/* Host Controller */
#define	EHCI_UM_ES		0x00000004	/* R/WO Endian Select */
#define	EHCI_UM_ES_LE		0x0	/* Little-endian byte alignment */
#define	EHCI_UM_ES_BE		0x4	/* Big-endian byte alignment */
#define	EHCI_UM_SDIS		0x00000010	/* R/WO Stream Disable Mode */

#define	EHCI_PORT_RESET_COMPLETE	2	/* ms */

#endif	/* _EHCIREG_H_ */