config root man

#########################################################################
#
#          Example of ppp.linkup file
#
#  This file is checked when ppp establishes a connection.
#  ppp searches the labels in this file as follows:
#
#  1) The label that matches the IP number assigned to our side.
#
#  2) The label specified on the command line to ppp.
#
#  3) If no label has been found, use MYADDR if it exists.
#
#
# $FreeBSD: release/9.1.0/share/examples/ppp/ppp.linkup.sample 192799 2009-05-26 07:40:32Z brian $
#
#########################################################################

# It is no longer necessary to re-add the default route here as our
# ppp.conf route is `sticky' (see the man page).
# If you're into sound effects when the link comes up, you can run
# ``auplay'' (assuming NAS is installed and configured).
#
MYADDR:
 !bg /usr/X11R6/bin/auplay /etc/ppp/linkup.au

# If we've got 192.244.176.32 as our address, then regard peer as a gateway
# to 192.244.176.0 network.  This may also be done in ppp.conf instead.
#
192.244.176.32:
 add 192.244.176.0 0 HISADDR

# You may want to execute a script after connecting.  This script can do
# nice things such as kick off "sendmail -q", "popclient my.isp" and
# "slurp -d news".  It can be passed MYADDR, HISADDR and INTERFACE
# as arguments too - useful for informing a DNS of your assigned IP.
#
# NOTE: It's vital that you use ``!bg'' rather than ``!'' if the program
#       you're running will take some time or will require network
#       connectivity.  Using ``!'' will delay ppp 'till the completion
#       of the program being run!
#
# You may also want some sound effects....
#
pmdemand:
 !bg /etc/ppp/ppp.etherup.pmdemand
 ! sh -c "cat /etc/ppp/linkup.au >/dev/audio"

# If your minimum call charge is 5 minutes, you may as well stay on
# the line for that amount of time.  If we want a 60 second subsequent
# timeout, set your timeout to 300 in ppp.conf and then do this:
# 
min5minutes:
 !bg sh -c "sleep 240; pppctl -p mypassword 3000 set timeout 60"